Search Results "Wheelchair Space (Transportation)"

• Federal Documents > Regulations > 49 CFR Parts 37 & 38 - Department of Transportation (DOT) ADA Regulations
  § 37.21(b)

  (b) For entities receiving Federal financial assistance from the Department of Transportation, compliance with applicable requirements of this part is a condition of compliance with section...

• Federal Documents > Technical Assistance > ADA Information Services
  Project ACTION

  Project ACTION is funded by the Department of Transportation to provide information about making transportation accessible....

• State and Local Documents > Codes and Standards > 2022 California Standards
  11B-804.6.1 Clear floor or ground space

  A clear floor or ground space complying with Section 11B-305 shall be provided at each kitchen appliance. Clear floor or ground spaces shall be permitted to overlap....

• State and Local Documents > Guidelines > 2013 Forest Service Trail Accessibility Guidelines (FSTAG)
  305 Clear Floor or Ground Space for Wheelchairs

  [See subsections ...]

• Federal Documents > Standards > 1991 ADA Standards for Accessible Design
  4.2.4* Clear Floor or Ground Space for Wheelchairs.

  [See subsections ...]

• Federal Documents > Technical Assistance > 2013 Forest Service Outdoor Recreation Accessibility Guidelines (FSORAG)
  305 Clear Floor or Ground Space for Wheelchairs

  [See subsections ...]

• Federal Documents > Standards > Uniform Federal Accessibility Standards (UFAS)
  4.2.4* CLEAR FLOOR OR GROUND SPACE FOR WHEELCHAIRS

  [See subsections ...]

• State and Local Documents > Codes and Standards > 2022 California Standards
  11B-206.7.3 Incidental spaces

  Platform lifts shall be permitted to provide an accessible route to incidental spaces which are not public use spaces and which are occupied by five persons maximum....

• Federal Documents > Technical Assistance > Title III Technical Assistance Manual (with 1994 supplement)
  III-7.5180 Assembly areas

  This section specifies the number of wheelchair seating spaces and types and numbers of assistive listening systems required in assembly areas. 1) Wheelchair seating: Requirements for...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  2004 ADA and ABA Accessibility Guidelines

  surfaces on diagnostic equipment used by patients in a supine, prone, or side-lying position and diagnostic equipment used by patients in a seated position (see M301.2.1 and M302.2.1); • Wheelchair...

• Federal Documents > Regulations > 49 CFR Parts 37 & 38 - Department of Transportation (DOT) ADA Regulations
  6. Eating and Drinking

  or another medical condition requests to eat or drink aboard a vehicle or in a transit facility in order to avoid adverse health consequences, the request should be granted, even if the transportation...

• Products and Additional Resources > Products
  Hussey Seating Company Skid-Mounted and Companion Chairs
  

  Seats are mounted on skids for standard seating, and the entire assembly can be unbolted and removed at a moment’s notice to accommodate wheelchair patrons....

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  Folding Seats on Equipment Used by Patients Seated in a Wheelchair (M302.4 Exception)

  M302.4 includes an exception for diagnostic equipment that is designed for use by patients seated in a wheelchair and provides a folding seat....

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.3.3.2 Cross Slope

  The cross slope of ramp runs shall not be steeper than 1:48.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M303.3.3 Ramped

  Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height

  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height. Edge protection is not required on platforms 1 ½ inches or less in height.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations

  5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations The Committee recommends a two-inch high edge protection on the back of the...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.1 Ramped Entry Slope

  5.8.1.2.1 Ramped Entry Slope. Raised platforms should have a ramp with slopes that do not exceed the following: Rise 0 to 1 ½ inches – 1:2 Slope Rise >1 ½ to 2 ½ inches – 1:8...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides

  5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides. A minimum 2 inch high edge protection must be provided on both sides of the platform for double ramped entry...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.2 Single Ramped Entry – Edge Protection on the Platform and Platform Sides

  5.8.1.2.2 Single Ramped Entry – Edge Protection on the Platform and Platform Sides. A 2 inch high edge protection must be provided on the back of the platform, opposite the entry...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height Recommendations

  5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height Recommendations The Committee recommends that no edge protection be required on platforms of 1½ inches or less...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations

  5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations The Committee recommends a minimum two-inch high edge protection on both sides of the...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.3.3.2 Cross Slope

  The cross slope of ramp runs shall not be steeper than 1:48.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M303.3.3 Ramped

  Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.