[See subsections ...]
Search Results "Transfer Space"
-
11B-305 CLEAR FLOOR OR GROUND SPACE
-
305 Clear Floor or Ground Space for Wheelchairs
[See subsections ...]
-
4.2.4* Clear Floor or Ground Space for Wheelchairs.
[See subsections ...]
-
305 Clear Floor or Ground Space for Wheelchairs
[See subsections ...]
-
4.2.4* CLEAR FLOOR OR GROUND SPACE FOR WHEELCHAIRS
[See subsections ...]
-
11B-305 Clear floor or ground space.
[See subsections ...]
-
11B-305 Clear floor or ground space
[See subsections ...]
- Figure 1009.4.5 Grab Bars for Transfer Walls – Drawing from the U.S. Access Board
-
M302.2.3 Size (Section-by-Section Analysis)
The Access Board also solicited comment in question 16 on whether the transfer surface size proposed for seated position diagnostic equipment was sufficient to facilitate independent transfer...
-
Turning Space [§304]
Turning Space [§304] Turning space is required in these accessible rooms and spaces: toilet and bathing facilities dressing, fitting, and locker rooms transient...
-
11B-813.2.10 Door swing
A door, in any position, shall be permitted to encroach into the turning space by 12 inches (305 mm) maximum....
-
11B-612.2 Bench
Doors shall not swing into the clear floor space required by Section 11B-903.2....
-
11B-612.2 Bench
Doors shall not swing into the clear floor space required by Section 11B-903.2....
-
11B-813.2.10 Door swing
A door, in any position, shall be permitted to encroach into the turning space by 12 inches (305 mm) maximum....
-
5.4.1 Transfer Support Location for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.1 Transfer Support Location for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
703.5.8 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces....
-
5.4.2 Transfer Support Length for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.2 Transfer Support Length for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
M302.2.3 Size
Transfer surfaces shall be 21 inches (610 mm) wide minimum and 17 inches (430 mm) deep minimum....
-
M302.2.2 Size
The transfer surface shall be 21 inches (610 mm) wide minimum and 15 inches (381 mm) deep minimum. Advisory M302.2.2 Size....
-
R403.2 Clear Space
R403.2 Clear Space. A clear space complying with R404 shall be provided at operable parts....
-
Turning Space
Turning Space Piers and platforms must have at least one turning area, either a 60-inch turning space or T-shaped space, to allow a person using a mobility device or wheelchair to make...
-
E202.4 Functions Located in Maintenance or Monitoring Spaces (Section-by-Section Analysis)
E202.4 Functions Located in Maintenance or Monitoring Spaces (Section-by-Section Analysis) This section proposes to revise § 1194.3(f) of the existing 508 Standards to clarify that, where...
-
11B-221.2.1.1 General seating
Wheelchair spaces complying with Section 11B-802.1 shall be provided in accordance with Table 11B-221.2.1.1....
-
11B-221.2.1.1 General seating
Wheelchair spaces complying with Section 11B-802.1 shall be provided in accordance with Table 11B-221.2.1.1....