Search Results "Side Grab Bar"

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M301.2.3 Size

  The size of transfer surfaces shall be measured from center points of their opposing sides....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.2.1.1 Transfer Surface Width

  The transfer surface should be 28 inches wide minimum for equipment used by patients in a supine, side-lying, or prone position....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.2.1.2 Transfer Surface Depth

  The transfer surface should be 17 inches deep minimum for all equipment used by patients in a supine, side-lying, or prone position with the exception of imaging equipment....

• Legal Documents > United States of America v. Humboldt County, California - Consent Decree
  Attachment I: Program Access in Existing Facilities

  Attachment I: Program Access in Existing Facilities

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M301.1 General

  Diagnostic equipment that supports patients in a supine, prone, or side-lying position shall comply with M301. ...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  M301.2.1 Transfer Surface Height

  The table side covers have the same issues discussed for the CT table in Figure 5.3-1....

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M305.2.7 Clearance (Section-by-Section Analysis)

  However, in the preamble to the MDE NPRM the Access Board noted that it was considering applying the 2004 ADA and ABA Accessibility Guidelines for clearance around grab bars to the transfer...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4.8 Transfer Support Gripping Surface Hazard Recommendation for M301 and M302

  This provision, like those above, originates in the technical provisions for grab bars in the 2010 Standards...

• Webinars, Videos, and Training > Product Demonstration or Information
  ACCESSMAT® - EN - Beach accessibility mats
  

  AccessMat® is a lightweight and durable 100% polyester roll out matting system specifically developed to create a permanent or temporary route for individuals of all abilities...

• Products and Additional Resources > Products
  Midmark 641 Barrier-Free® Power Procedures Chair
  

  Narrow patient support surface, slim back section and tuck away side rails provide maximum patient accessibility and supports proper posture Powered seat, back, foot and tilt offer multi-positioning...

• Federal Documents > Preamble to Guidelines > 36 CFR Part 1191 ABA Accessibility Guidelines, Outdoor Developed Areas - Preamble
  Costs

  The regulatory assessment compares the final rule to the guidelines and standards used by federal agencies for the design of outdoor developed areas without regard to accessibility...

• Federal Documents > Technical Assistance > 2013 Forest Service Outdoor Recreation Accessibility Guidelines (FSORAG)
  6.14.1 Clear Width

  Gate openings and openings in barriers for pedestrian passage shall provide a clear width of 36 inches (915 mm), complying with ODAAG, section 1017.3 Clear Tread Width.

• Additional Access Publications > A Guide to Planning Accessible Meetings
  Food and Beverage Service

   The Food Service: Accommodating Diners with Disabilities factsheet provides both legal standards and promising practices for paths of travel, approach to dining spaces, seating,...

• State and Local Documents > Guidelines > 36 CFR Part 1191 ABA Accessibility Guidelines, Outdoor Developed Areas
  F202.4 Alterations Affecting Primary Function Areas

  * * * * * EXCEPTIONS: * * * * * 2. Camping facilities, picnic facilities, viewing areas, trailheads, trails, and beach access routes shall not be required to comply with...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  M305.2.3 Fittings

  M305.2.3 Fittings Proposed requirement: Transfer supports shall not rotate within their fittings • Sub-Committee Recommendation: Transfer supports shall not rotate within...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  Overhead Lifts

  The technical criteria do not address overhead lifts that are usually mounted on the ceiling and operate on tracks suspended over the diagnostic equipment because the configuration...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  Clearance in Base (M301.4.1 and M302.4.1)

  Clearance in the base of the equipment allows the legs of a portable floor lift to fit under the base of the equipment. The clearance can be an open area between the supporting posts...

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M301.3.1 Transfer Supports (Section-by-Section Analysis)

  The MDE NPRM proposed to require transfer supports to be provided for use with transfer sides on diagnostic equipment used by patients in the supine, prone, or side-lying position, and that...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4.3 Transfer Support Height for M301 and M302

  whether 6 inches minimum and 19 inches maximum above the transfer surface would be an appropriate height for transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying...

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M301.3.2 Leg Supports (Section-by-Section Analysis)

  In the MDE NPRM, the Access Board proposed to place the requirements for stirrups on diagnostic equipment used by patients in the supine, prone, or side-lying position in M301....

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M301.3.1 Transfer Supports

  Transfer supports shall be provided for use with the transfer sides required by M301.2.3 and shall comply with M305.2....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.2.1.1 Transfer Surface Width Recommendations for M301

  5.2.1.1 Transfer Surface Width Recommendations for M301 The Committee recommends a transfer surface of 28 inches minimum width for equipment used by patients in a supine, side-lying,...