benefits justify its costs; tailor the regulation to impose the least burden on society, consistent with obtaining the regulatory objectives; and, in choosing among alternative regulatory approaches...
Search Results "Parallel Approach"
-
Executive Order 13563 (Improving Regulation and Regulatory Review) and Executive Order 12866 (Regulatory Planning and Review): Preliminary Regulatory Assessment
-
Stanley Hardware RP9401 Door Closer
valves, which allow for fine tune adjustments Non-handed All season fluid eliminates the need for seasonal adjustments Includes tri-pack mounting hardware for regular, top-jamb and parallel...
-
Allegion Falcon SC90 Series Surface Mounted Door Control
Specifications Meets ANSI A117.1 ANSI/BHMA A156.4, Grade 3 UL Listed Closer mounts hinge side, top jamb or parallel arm when either the Rw/PA or Hw/PA arm...
-
9.b [§ 4.7.5]
The level should be placed so that it is parallel to the curb. Place the level in the same position and location as each of the arrows in the illustration to the left [below]....
-
11B-307.4 Vertical clearance
Where a guy support is used parallel to a circulation path, including but not limited to sidewalks, a guy brace, sidewalk guy or similar device shall be used to prevent an overhanging obstruction...
-
13 [§ 4.7.10]
When taking this measurement, the measuring tape should be aligned parallel to the ramp run itself and should stretch from the intersection of the ramp and gutter to the innermost edge of...
-
11B-406 CURB RAMPS, BLENDED TRANSITIONS AND ISLANDS
Parallel curb ramps and blended transitions, although permitted by 2010 ADAS, are not defined or given special attention. ...
-
11B-502.6.4.2
The centerline of the International Symbol of Accessibility shall be a maximum of 6 inches (152 mm) from the centerline of the parking space, its sides parallel to the length of the parking...
-
Unified Facilities Guide Specifications
published by the National Institute of Building Sciences, it is stated that surfaces should be tested with a 4 - meter (12 ft) straightedge in both a longitudinal and transverse direction on parallel...
-
11B-307.4 Vertical clearance
Where a guy support is used parallel to a circulation path, including but not limited to sidewalks, a guy brace, sidewalk guy or similar device shall be used to prevent an overhanging obstruction...
-
11B-809.10.5.1 Clear floor space
A clear floor space 30 inches (762 mm) minimum by 48 inches (1219 mm) minimum shall be located with the long edge of the clear floor space parallel to the side of the bathtub or bathtub-shower...
-
406.6 Diagonal Curb Ramps
Diagonal or corner type curb ramps with returned curbs or other well-defined edges shall have the edges parallel to the direction of pedestrian flow....
-
Question 10
the building free of obstacles that block the clear wall and floor space needed for opening the door (between 18 and 42 inches on the latch side of the door, depending on direction of approach...
-
Entrance
An entrance includes the approach walk, the vertical access leading to the entrance platform, the entrance platform itself, vestibules if provided, the entry door(s) or gate(s), and the...
-
11B-902.4.1 Clear floor or ground space
A clear floor space complying with Section 11B-305 positioned for forward approach shall be provided....
-
Triggering event
This triggering event parallels that for the alterations provisions (i.e., the date on which construction begins), and would apply clearly across all types of covered public accommodations...
-
1124B
Size and approach. The minimum clear floor or ground space required to accommodate a single, stationary wheelchair and occupant is 30 inches by 48 inches (762 mm by 1219 mm)....
-
(1) Transfer Surface Location for Diagnostic Equipment Used in the Supine, Prone, or Side-lying Position
as stretchers and the scanning beds of many types of imaging machines, the foot end is not intended as a transfer point; patients transfer onto the surface on either of the long sides, approaching...
-
Triggering event. (Section-by-Section Analysis)
This triggering event parallels that for the alterations provisions (i.e., the date on which construction begins), and would apply clearly across all types of covered public accommodations...
-
Substitute cells. (Section-by-Section Analysis)
The majority who chose to comment supported an approach that allowed substitute cells to be made accessible within the same facility....
-
FIGURE INDEX
Figure 305.7.2 Maneuvering Clearance in an Alcove, Parallel Approach Figure 306.2 Toe Clearance Figure 306.3 Knee Clearance Figure 307.2 Limits of Protruding...
-
Question 19
fitting rooms free of obstacles that block the clear wall and floor space needed for opening the door (between 18 and 42 inches on the latch side of the door, depending on direction of approach...
-
Individuals with Hearing Impairments or Deafness
., the sound of approaching traffic or cyclists ringing a bell)....
-
Are spring hinges and gravity hinges considered “closers” in determining the size of maneuvering clearances?
Some approaches require additional maneuvering clearances when a door or gate is equipped with a closer because of the additional force that must be counteracted in proceeding through doors...
