transfer surface....
Search Results "Transfers of Privately Held Equity Interest"
Filters
Commonly Searched Documents
-
19 Inch Low Height
-
5.4.1.2 Transfer and Positioning Support Location for Imaging Equipment
5.4.1.2 Transfer and Positioning Support Location for Imaging Equipment....
-
M301.2.2 Sunset Provision (Section-by-Section Analysis)
(Significant Changes – Transfer Surface Adjustability), this is a new provision that was added to the final rule in conjunction with the new requirement of a low height range in M301.2.1...
-
M305.2.1 Location (Section-by-Section Analysis)
, and requiring the transfer support to be located on the side of the transfer surface opposite the transfer side....
-
Addendum D: Comparison of demographics and transfer height between Phase 1 and Phase 2 of the study
[See subsections ...]
-
1014.1 General
The technical requirements address the entrance to camp shelters (1014.2), including transfer access (1014.2.1) and roll-in access (1014.2.2); and the floor within camp shelters (1014.3)...
-
Non-Positive Shut-off
People are always asking what the term non-positive shut-off means. It's not well-documented but I believe that it refers to a handheld valve that makes the shower head continue to...
-
Shower Stalls [4.21]
ADAAG provides specifications for several types of shower stall designs: roll-in, transfer, and, in hotels (section 9), a combination of the two....
-
Figure 1009.4.5 Grab Bars for Transfer Walls – Drawing from the U.S. Access Board
-
5.4.5 Transfer Support Position for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.5 Transfer Support Position for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
11B-206.6 Elevators
Elevators provided as a means of access within a private residence shall be installed so that they are not accessible to the general public or to other occupants of the building....
-
M302.3 Supports
Transfer supports, armrests, and reclining surfaces shall comply with M302.3....
-
M302.3 Supports
Transfer supports, leg supports and reclining surfaces shall comply with M302.3....
-
18 Inch Low Height
could be a reasonable compromise since the group most affected by increasing the height would be manual wheelchair users who could accommodate a 1 inch change in vertical clearance during transfer...
-
§ 37.7(b)
(b)
-
§ 37.7(b)(2)(ii)
(ii) Specific provision of part 38 of this title concerning which the entity is seeking a determination of equivalent facilitation.
-
606.3 Height
A lavatory in a toilet or bathing facility for a single occupant accessed only through a private office and not for common use or public use shall not be required to comply with 606.3....
-
5.2.1.4 Transfer Surface Size for Imaging Equipment
5.2.1.4 Transfer Surface Size for Imaging Equipment. The transfer surface should be 28 inches wide minimum and 21 inches deep minimum....
-
Figure 608.3.1 Grab Bar for Transfer Type Showers – Drawing from the U.S. Access Board
-
Figure 1009.4.1 Clear Deck Space at Transfer Walls – Drawing from the U.S. Access Board
-
606.3 Height
A lavatory in a toilet or bathing facility for a single occupant accessed only through a private office and not for common use or public use shall not be required to comply with 606.3....
-
606.3 Height
A lavatory in a toilet or bathing facility for a single occupant accessed only through a private office and not for common use or public use shall not be required to comply with 606.3....
-
Chapter 4: Implications for standards and design
[See subsections ...]
-
§27.11(c) Compliance planning.
(c) Compliance planning.
