The Class Representatives and Class Counsel (the attorneys appointed by the Court to represent the Class) think the proposed settlement is in the best interests of the Class Members taking...
Search Results "Best Meets"
-
BASIC INFORMATION
-
3. Camera
Surveying takes a lot of concentrated effort, it can be physically taxing, and even the best surveyors can make mistakes when they become tired. Photos fill in the gaps....
-
L.
were approved by the Texas Department of Licensing and Regulation as accessible under the Texas Accessibility Standards, state accessibility regulations certified by the United States as "meeting...
-
M301.4 Lift Compatibility
EXCEPTION: Where fixed overhead patient lifts are provided, and when their use with diagnostic equipment is permitted by an enforcing authority, diagnostic equipment shall not be required to meet...
-
M302.4 Lift Compatibility
EXCEPTION: Where fixed overhead patient lifts are provided, and when their use with diagnostic equipment is permitted by an enforcing authority, diagnostic equipment shall not be required to meet...
-
Dressing, Fitting, or Locker Rooms
Operating mechanisms provided on accessible lockers must also meet ADAAG provisions for their operation and height....
-
STEP 2 Determine what is needed
STEP 2 Determine what is needed In some cases, the accessibility guidelines will require additional play components to be provided to meet the minimum requirements. ...
-
5. When Is It Important for My Client to Request a Reasonable Accommodation?
Because an employer does not have to excuse failure to meet production standards that are consistently applied, even if the difficulty was caused by a health condition or the side effects...
-
Requirement 4. Accessible route into and through the covered dwelling unit.
Guideline Accessible routes into and through dwelling units would meet section 100.205(c)(3)(i) if:...
-
§ 37.42(d)(2)
(2) The railroad operator must submit a plan to FRA and/or FTA, describing its proposed means to meet the performance standard of paragraph (a) of this section at that station....
-
Standard Units
It is important that cantilevered units meet the requirements for protruding objects so they do not pose a hazard to people with vision impairments....
-
State and Local Government Facilities
Federal facilities are not covered by the ADA, but by an earlier law, the Architectural Barriers Act (ABA) and must meet separate, though very similar, standards....
-
Are curved or circular ramps allowed?
Ramps without level landings at changes in direction typically will not meet the Standards due to resulting compound slopes....
-
§ 37.42(d)(2)
(2) The railroad operator must submit a plan to FRA and/or FTA, describing its proposed means to meet the performance standard of paragraph (a) of this section at that station....
- International Society of Wheelchair Professionals (ISWP)
-
Ground Surfaces
The Department is aware that there is an ongoing controversy about play area ground surfaces arising from a concern that some surfaces that meet the ASTM requirements at the time of installation...
-
National Council on Independent Living
The Subcommittees spent way too much time trying to solve engineering problems, when the point was to understand accessibility needs and meet them....
-
Section 37.167 Other Service Requirements
This is a judgmental matter best left to the local planning process....
-
Issue: Program Accessibility
Common Problem: City governments often have failed to ensure that the whole range of the city’s services, municipal buildings, and programs meet Title II’s program access requirements...
-
5.2.1.4 Transfer Surface Size Recommendations for Imaging Equipment (M301)
All X-ray tables meet the 28-inch table width....
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
Acquired products that meet the specific technical provisions set forth in Subpart B will also meet the broader functional performance criteria in Subpart C....
-
1. Making Facilities Accessible and Usable
not required to make its existing facilities accessible until a particular applicant or employee with a particular disability needs an accommodation, and then the modifications should meet...
-
3. Testing and Labeling of Electronic Respiratory Assistive Devices
At present, a label indicating that the device complies with RTCA standards meets FAA requirements and need not specifically state that the device is FAA approved....