5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations The Committee recommends a minimum two-inch high edge protection on both sides of the...
Search Results "Wheelchair Space (Assembly)"
2010 ADA Definition
Wheelchair Space (Assembly): Space for a single wheelchair and its occupant.
Filters
Commonly Searched Documents
-
5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations
-
M303.3.3.2 Cross Slope
The cross slope of ramp runs shall not be steeper than 1:48.
-
M303.3.3 Ramped
Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.
-
M303.3.3.4 Edge Protection
Ramps with drop offs ½ inch (13 mm) or greater shall provide edge protection 2 inches (50 mm) high minimum on each side.
-
304 Turning Space
Minimum spatial requirements are specified for wheelchair turning space. This section permits either a 60 inch diameter circle or a T-shaped design....
-
§382.65(c)
(c) You must ensure that on-board wheelchairs meet the following standards:...
-
§382.129 What other requirements apply when passengers' wheelchairs, other mobility aids, and other assistive devices must be disassembled for stowage?
[See subsections ...]
-
Floor or Ground Surfaces: ADA Standard Section 305.2
Section 305.2 covers the current ADA Standards for floor or ground surfaces of clear floor or ground space.
-
4.1.3(19)(b)
(b) This paragraph applies to assembly areas where audible communications are integral to the use of the space (e.g., concert and lecture halls, playhouses and movie theaters, meeting rooms...
-
Clear Floor Space
The minimum unobstructed floor or ground space required to accommodate a single, stationary wheelchair and occupant....
-
11B-806.2.2 Exterior spaces
Exterior spaces, including patios, terraces and balconies that serve the guest room shall be accessible....
-
11B-809.2.2 Turning space
All rooms served by an accessible route shall provide a turning space complying with Section 11B-304....
-
11B-603.2.3 Door swing
Doors shall not swing into the clear floor space or clearance required for any fixture....
-
11B-1005.5 Turning space
At least one turning space complying with Section 11B-304.3 shall be provided on fishing piers and platforms....
-
11B-603.2.2 Overlap
Required clear floor spaces, clearance at fixtures, and turning space shall be permitted to overlap....
-
Figure 305.5 Position of Clear Floor or Ground Space – Drawing from the U.S. Access Board
-
Vehicle Spaces: ADA Standard Section 502.2
Section 502.2 covers the current ADA Standards for vehicle spaces.
-
382.131 Do baggage liability limits apply to mobility aids and other assistive devices?
382.131 Do baggage liability limits apply to mobility aids and other assistive devices? These provisions are substantively the same as their counterparts in the existing rule....
-
D. Accommodations for Air Travelers who are Deaf, Hard of Hearing, or Deaf-Blind
Carriers are responsible for ensuring that passengers with disabilities, including those with vision or hearing impairments, receive the same information in a timely manner that the...
-
4.2 Clear Floor Area
4.2 Clear Floor Area Figure 9 and Table 3 show the standards from the four countries related to clear floor area. Figures 10-13 show the key findings from the research. Figure...
-
Armrests: ADA Standard Section 802.4.1
Where armrests are provided on the seating in the immediate area, folding or retractable armrests shall be provided on the aisle side of the seat.
-
11B-802.4.1 Armrests
Where armrests are provided on the seating in the immediate area, folding or retractable armrests shall be provided on the aisle side of the seat.
-
Designated Aisle Seats
Comments stated that requiring designated aisle seats to be on an accessible route would require more space and entrances to seating areas and would result in the loss of seating space....
-
Figure 1009.5.2 Clear Deck Space at Transfer Platform – Drawing from the U.S. Access Board
