(f) If an escalator or stair is planned or installed where none existed previously and major structural modifications are necessary for such installation, then a means of accessible...
Search Results "Ramp Run"
Filters
Commonly Searched Documents
-
4.1.6(1)(f)
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
Accessible Routes on the Playing Surface
Where ramps change direction, the landing size must be a minimum of 48 inches by 60 inches....
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
Cross Slope and Surfaces [4.8.6]
Ramp surfaces must comply with requirements for ground and floor surfaces and be "stable, firm, and slip-resistant." A specific level of slip-resistance is not mandated....
-
5.9.2 Standing Supports on Ramped Entry Raised Platforms with Wheelchair Spaces
5.9.2 Standing Supports on Ramped Entry Raised Platforms with Wheelchair Spaces....
-
seca 676 r Digital Wheelchair Scale with Handrail and Integrated RS232 Interface
Two ramps included. Pre-TARE function with three memory cells....
-
5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations
5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations The Committee recommends a two-inch high edge protection on the back of the platform...
-
seca 684 r Digital Multifunctional Scale with Integrated RS232 Interface
Ramp seca 470 included. TARE, Auto-HOLD and damping function. Integrated transport castors allow for easy mobility....
-
Problem Three (Accessible Route)
Solution: Install a portable ramp....
-
M303.3.3.2 Cross Slope
The cross slope of ramp runs shall not be steeper than 1:48....
-
M303.3.3.2 Cross Slope
The cross slope of ramp runs shall not be steeper than 1:48....
-
Stabila, Inc. Magnetic Tech Digital Electronic Level Type 96M-2
easy viewing from any angle Electronic displays illuminate for easy viewing in low light conditions 5 display modes (degrees in 1 or 2 decimal points, percent, feet & inches (rise/run...
-
11B-505.9 Fittings
Handrails shall not rotate within their fittings.
-
505.9 Fittings
Handrails shall not rotate within their fittings.
-
505.9 Fittings
Handrails shall not rotate within their fittings.
-
505.9 Fittings
505.9 Fittings. Handrails shall not rotate within their fittings.
-
§ 36.304(b)(2)
(2) Making curb cuts in sidewalks and entrances;
-
Sec.36.304(b)(2)
(2) Making curb cuts in sidewalks and entrances;
-
4.8.4(4)
(4) If a doorway is located at a landing, then the area in front of the doorway shall comply with 4.13.6.
-
505.9 Fittings
Handrails shall not rotate within their fittings.
-
Transition to Street [§406.2]
Transition to Street [§406.2]
-
11B-505.9 Fittings
Handrails shall not rotate within their fittings.
