A sign containing raised characters and/or symbols and accompanying Braille....
Search Results "Raised Crossing"
Filters
Commonly Searched Documents
-
TACTILE SIGN
-
Obstacles [1018.5]
Where possible, separate obstacles that cross the entire beach access route by at least 48 inches so that people using mobility devices can fully cross one obstacle before confronting another...
-
11B-502.3 Access aisle
In parking facilities where the accessible route must cross vehicular traffic lanes, marked crossings enhance pedestrian safety, particularly for people using wheelchairs and other mobility...
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised position. [2010 ADAS] 1009.2.6 Footrests and Armrests. ...
-
V. Discussion of Principal Public Comment Issues, and Section-by-Section Analysis of the Final Guidelines
The following presents a discussion of the principal issues raised by the commenters, and the Department's response to each issue....
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised position. [2010 ADAS] 1009.2.6 Footrests and Armrests....
-
11B-1009.2.6 Footrests and armrests
The armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised (load) position....
-
Obstacles [1016.5]
Frequent obstacles and obstacles that cross the full width of an ORAR can make travel difficult for people using mobility devices....
-
1117B.5.5, Item 2
California's standards for signage are more stringent than Section 4.30 of the ADA Standards for Accessible Design. 1117B.5.5 Raised characters and pictorial symbol signs. ...
-
American Specialties Folding Utility Shelf for Toilet Compartments 0698
Fabricated of 18 gauge type 304 satin finish stainless steel with raised rim. Returns to upright position when not in use. ...
-
Audible WALK indications
close to the crossing it signals.3 Speech WALK indication. ...
-
Expert Report of John Rife Torkelson, theACCESSpartnership, L.P. (August 8, 2018)
Building Entrance: The raised threshold at the exterior entrance exceeds 1/2 inch (1991 ADA Stds 4.13.8; 2010 ADA Stds 404.2.5)....
-
4. Comparison of Proposed Technical Provisions Applicable to Shared Use Paths and AASHTO Guide
R302.5.3 Within Pedestrian Street Crossings....
-
405.4 Floor or Ground Surfaces
Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
405.4 Floor or Ground Surfaces
Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
R306.3.2 Pedestrian Activated Signals
At roundabouts with multi-lane pedestrian street crossings, a pedestrian activated signal complying with R209 shall be provided for each multi-lane segment of each pedestrian street crossing...
-
1.1.7 Measurement of parking areas
Overall running slope (in the long dimension) and cross slope (in the short direction) should be measured according to Section 1.1.3 and 1.1.4....
-
11B-703.3.2 Position
Braille shall be separated 3/8 inch (9.5 mm) minimum and ½ inch (12.7 mm) maximum from any other tactile characters and 3/8 inch (9.5 mm) minimum from raised borders and decorative elements...
-
11B-703.3.2 Position
Braille shall be separated 3/8 inch (9.5 mm) minimum and ½ inch (12.7 mm) maximum from any other tactile characters and 3/8 inch (9.5 mm) minimum from raised borders and decorative elements...
-
11B-703.3.2 Position
Braille shall be separated 3/8 inch (9.5 mm) minimum and ½ inch (12.7 mm) maximum from any other tactile characters and 3/8 inch (9.5 mm) minimum from raised borders and decorative elements...
-
703.3.2 Position
Braille shall be separated 3/8 inch (9.5 mm) minimum from any other tactile characters and 3/8 inch (9.5 mm) minimum from raised borders and decorative elements....
-
703.3.2 Position
Braille shall be separated 3/8 inch (9.5 mm) minimum from any other tactile characters and 3/8 inch (9.5 mm) minimum from raised borders and decorative elements....
-
H1
.), is a sign with raised characters and Braille mounted on the wall adjacent to the latch?...
-
M301.3 Transfer Supports
Circular cross sections – Circular cross sections must have an outside diameter of 1¼ inches minimum and 2 inches maximum....
