[DSA-AC & HCD 1-AC] Accessibility is the combination of various elements in a building, facility, site, or area, or portion thereof which allows access, circulation and the full use...
Search Results "Model Building Code"
Commonly Searched Documents
-
ACCESSIBILITY
-
11B-809.5.2 Residential dwelling unit smoke detection system and carbon monoxide detection system
ETA Editor's Note The lengthy California Building Code Chapter 9, Section 907.2.11 referenced above is not adopted by Division of the State Architect - Access Compliance (DSA-AC), and...
-
11B-809.5.2 Residential dwelling unit smoke detection system and carbon monoxide detection system
ETA Editor's Note The lengthy California Building Code Chapter 9, Section 907.2.11 referenced above is not adopted by Division of the State Architect - Access Compliance (DSA-AC), and...
-
201.4 Scope of Coverage
This code applies to fixed or built-in elements of buildings, structures, site improvements and pedestrian routes or vehicular ways located on a site....
-
ACCESSIBILITY
[DSA-AC & HCD 1-AC] Accessibility is the combination of various elements in a building, facility, site, or area, or portion thereof which allows access, circulation and the full use...
-
4.3.6 Reach Limits
The corresponding percentages are color coded to differentiate regions of reach performance....
-
GRADE (Adjacent Ground Elevation)
[DSA-AC & HCD 1-AC] The lowest point of elevation of the finished surface of the ground, paving or sidewalk within the area between the building and the property line or, when the property...
-
GRADE (Adjacent Ground Elevation)
[DSA-AC & HCD 1-AC] The lowest point of elevation of the finished surface of the ground, paving or sidewalk within the area between the building and the property line or, when the property...
- Schumacher 1400 Series Limited Use Limited Application (LULA) Elevator
- American Stair Corp. Standard Railings
-
11B-1005.2.1 Height
[2010 ADAS] EXCEPTION: Where a guard complying with sections 1003.2.12.1 and 1003.2.12.2 of the International building Code (2000 edition) or sections 1012.2 and 1012.3 of the International...
-
Scoping [4.1.2(6), 4.1.3(11)]
Scoping [4.1.2(6), 4.1.3(11)] Building codes, plumbing codes, or health regulations in force locally define the number and type of toilet/bathing facilities (and fixtures) required in...
-
GRADE (Adjacent Ground Elevation)
[DSA-AC & HCD 1-AC] The lowest point of elevation of the finished surface of the ground, paving or sidewalk within the area between the building and the property line or, when the property...
-
The Americans with Disabilities Act of 1990
It uses as its model Section 504's definition of disability and then goes further....
-
Sec.36.607(a)(2)
(2) For example, if certain equipment is not covered by the code, the determination of equivalency cannot be used as evidence with respect to the question of whether equipment in a building...
-
4.1.7(2)(a) Alterations to Qualified Historic Buildings and Facilities Subject to Section 106 of the National Historic Preservation Act
(a) Alterations to Qualified Historic Buildings and Facilities Subject to Section 106 of the National Historic Preservation Act:...
-
11.3 Q. The site analysis test calls for a calculation of the percentage of the buildable areas having slopes of less than 10 percent. What is the definition of buildable areas?
The buildable area is any area of the lot or site where a building can be located in compliance with applicable codes and zoning regulations....
- TownSteel Resetting factory mode for XCE XME 2000 series
-
1. LEGAL ISSUES
Attorney General’s office, developing guidelines for construction tolerances "…unnecessarily encourages contractors and others to deviate from the access regulations found in the California Building...
-
Accidental cueing of the audio
Accidental cueing of the audio A bump could activate the audio and at other times direct pressure to the model didn’t turn it on....
-
11B-504.5 Nosings
Exception: In existing buildings there is no requirement to retroactively alter existing nosing projections of 1½ inches (38 mm) which were constructed in compliance with the building code...
-
2. REGULATORY BUILT-IN TOLERANCES
REGULATORY BUILT-IN TOLERANCES: California Building Code Section 1101B.5 indicates all dimensions are subject to conventional industry tolerances except where the requirement is stated as...
-
Fact Based Questions
Fact Based Questions Participants identified answers correctly an average of 8% more frequently when presented with full round models than with bas-relief models, and 12% more frequently...
-
General: ADA Standard Section 210.1
Section 210.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for stairways.