Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or supporting...
Search Results "Head Support"
-
610.4 Structural Strength
-
903.6 Structural Strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or supporting...
-
Undue Burden
The decision that a particular aid or service would result in an undue burden or fundamental alteration must be made by a high level official, no lower than a Department head, and must be...
-
The Roles of the Access Board and the Department of Justice
The Board consists of thirteen public members appointed by the President, of whom the majority must be individuals with disabilities, and the heads of twelve federal departments and agencies...
-
11B-805.4.3 Turning space
"Each side" includes both sides and the foot, but does not include the head unless the provision of care requires it....
-
11B-805.4.3 Turning space
"Each side" includes both sides and the foot, but does not include the head unless the provision of care requires it....
-
411.1.1 Decoding of Closed Captions (Section-by-Section Analysis)
Captions (Section-by-Section Analysis) This section proposes that, where audio-visual players and displays process video with synchronized audio, they must decode closed caption data and support...
-
§100.500(b)(2)
(2) A legally sufficient justification must be supported by evidence and may not be hypothetical or speculative....
-
11B-610.4 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or supporting...
-
609.8 Structural Strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the grab bar, fastener, mounting device, or supporting...
-
M302.1 General
Diagnostic equipment that supports patients in a seated position shall comply with M302. ...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or supporting...
-
§ 1194.2(a)(2)
(2) When procuring a product, if an agency determines that compliance with any provision of this part imposes an undue burden, the documentation by the agency supporting the procurement...
-
4.26.3(3)
Shear force induced in a fastener or mounting device from the application of 250 lbf (1112N) shall be less than the allowable lateral load of either the fastener or mounting device or the supporting...
-
11B-609.8 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the grab bar, fastener, mounting device, or supporting...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or supporting...
- AgrAbility - Arthritis Foundation, Indiana Chapter
- Haws AXION® MSR Barrier-Free Recessed Eye/Face Wash
-
Free-Standing Overhead Lifts
Free-Standing Overhead Lifts Another type of overhead lift is supported from a frame that rests on the floor....
-
M304.2 Standing Surface (Section-by-Section Analysis)
The requirement for slip resistant and standing supports has been moved under this new requirement applying to standing surfaces....
-
M301.1 General
Diagnostic equipment that supports patients in a supine, prone, or side-lying position shall comply with M301. ...
-
11B-602.5 Spout location
The spout shall be located 15 inches (381 mm) minimum from the vertical support and 5 inches (127 mm) maximum from the front edge of the unit, including bumpers. ...
-
4.26.3(4)
a direct tension force of 250 lbf (1112N) plus the maximum moment from the application of 250 lbf (1112N) shall be less than the allowable withdrawal load between the fastener and the supporting...
-
410.6 Real-Time Text Functionality (Section-by-Section Analysis)
Proposed 410.6 would require that, where ICT supports real-time voice communication, it must also support RTT functionality....