[See subsections ...]
Search Results "End-Opening Door"
Filters
Commonly Searched Documents
-
1132A.5 Maneuvering clearances at doors
-
Problem Four (Entrance)
Problem Four: The entrance door has a door knob and/or latch that requires tight pinching and twisting and is not accessible....
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area on the side to which the door swings shall extend 18 inches (457 mm) past the strike edge for all doors....
-
11B-405.7.5 Doorways
Doors, when fully open, shall not reduce the required ramp landing width by more than 3 inches (76 mm)....
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area on the side to which the door swings shall extend 18 inches (457 mm) past the strike edge for all doors....
-
11B-307.4 Vertical clearance
Exception: Door closers and door stops shall be permitted to be 78 inches (1981 mm) minimum above the finish floor or ground....
-
11B-307.4 Vertical clearance
Exception: Door closers and door stops shall be permitted to be 78 inches (1981 mm) minimum above the finish floor or ground. ...
-
FlexCounter™ - Window Door Combination
Product by Panda Windows & Doors Visit www.panda-windows.com for more information!...
-
Remove post (increase clear width at double leaf doors)
[See subsections ...]
-
I. Security
Is the security latch or bolt on the hall door mounted no higher than 48" above the floor so it is within the reach of persons who use wheelchairs and is it operable with one hand, without...
-
g-ii
Is the door hardware (e.g., lever, pull, push, panic bar) usable with one hand, without tight grasping, pinching, or twisting of the wrist, to allow people who may not be able to easily...
-
LaCantina Doors - Contemporary Clad Industrial
New work for LaCantina Doors introducing their new Contemporary Clad product line. lacantinadoors.com/...
-
Access Board: Accessible Route Openings
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
§ 38.113(a)(2)
(2) Doorways at ends of cars connecting two adjacent cars, to the maximum extent practicable in accordance with regulations issued under the Federal Railroad Safety Act of 1970 (49 CFR parts...
-
9.5.2(2)(b)
(b) sleeping space for homeless persons as provided in the scoping provisions of 9.1.2 shall include doors to the sleeping area with a minimum clear width of 32 in (815 mm) and maneuvering...
-
Visual Notification Devices
Visual Notification Devices Care must be taken that notification devices intended to signal a door knock or bell are separately wired....
-
10.3.2(4)
within plus or minus 1‒1/2 inches under all normal passenger load conditions, and the horizontal gap, measured when the vehicle is at rest, is no greater than 3 inches for at least one door...
-
BEA Inc. MS08 Door Access Touchless Activation Sensor (Wave to Open)
.), activates the door. This touchless feature greatly reduces the spread of bacteria commonly found on push plates requiring a physical touch for activation....
-
§ 38.173(b)
covered by paragraph (a) will operate in an accessible station, the design of vehicles shall be coordinated with the boarding platform design such that the horizontal gap between a vehicle door...
-
M102.1 Defined Terms (Section-by-Section Analysis)
However, the Access Board has decided to add six additional terms to this section; end transfer surface, examination chair, imagining [sic] equipment with bores, imagining [sic] bed, side...
-
Motorized Lift & Slide Door System by Panda
Product by Panda Windows & Doors - Visit www.panda-windows.com for more information!...
-
Inventory Control Devices
Inventory Control Devices It is important that inventory control or security devices not obstruct required maneuvering clearances at doors....
-
28 CFR Parts 35 and 36, Nondiscrimination on the Basis of Disability by Public Accommodations - Movie Theaters; Movie Captioning and Audio Description (NPRM)
The electronic Federal Docket Management System (FDMS) will accept comments until midnight Eastern Time at the end of that day....
