to grasp them from outside the vehicle while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches (760 mm) above the ramp...
Search Results "Diagonal Curb Ramp"
Commonly Searched Documents
-
§ 38.159(c)(8) Handrails
-
WILLITS, et al v. CITY OF LOS ANGELES - Settlement Terms
Willits v. City of Los Angeles Term Sheet as of March 30, 2015
-
WILLITS, et al v. CITY OF LOS ANGELES - Settlement Agreement and Release of Claims
UNITED STATES DISTRICT COURT CENTRAL DISTRICT OF CALIFORNIA CASE NO. CV 10-5782 CBM (RZx) SETTLEMENT AGREEMENT AND RELEASE OF CLAIMS MARK WILLITS, JUDY GRIFFIN,...
-
11B-250 Circulation paths
[See subsections ...]
-
§ 38.95(c)(1) Design load
Ramps or bridge plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with...
-
5.8.1.2.1 Ramped Entry Slope Recommendations
5.8.1.2.1 Ramped Entry Slope Recommendations The Committee recommends that raised platforms have a ramp with slopes that do not exceed the following: At 0 to 1½ inches, the slope...
-
Play Components: ADA Standard Section 1008.4
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with 1008.4....
-
11B-1008.4 Play components
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with Section 11B-1008.4....
-
Q1.) When a ramp has a maximum slope of 1:12 or 8.33%, is that considered a range of from 0% to 8.33% which would allow no slope greater than 8.33% or is that a simple maximum which would allow a tolerance above 8.33%? Similarly, is a cabinet countertop that can be no higher than 34” AFF a range of from 0” to 34” AFF with no additional height allowed, or is a tolerance allowed for variations in the floor surface or cabinet construction?
A1.) The consistent technical assistance on this question has been that both are subject to tolerances.
-
§ 38.23(a) General
., lift or ramp) complying with paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a securement location....
-
§ 38.95(c)(7) Stowage
A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps or bridge plates, including portable ramps or bridge plates stowed in the passenger...
-
505.1 General
Handrails provided along walking surfaces complying with 403, required at ramps complying with 405, and required at stairs complying with 504 shall comply with 505....
-
505.1 General
Handrails provided along walking surfaces complying with 403, required at ramps complying with 405, and required at stairs complying with 504 shall comply with 505....
- Bosch Power Tools - GPL-3 3 Point Laser
-
M303.3.3 Ramped (Section-by-Section Analysis)
The commenter, a medical association, concurred with the requirement for handrails on diagnostic equipment with ramps over six inches in height....
-
Location: ADA Standard Section 406.5
Section 406.5 covers the current ADA Standards for the location of curb ramps.
-
505.1 General
Handrails provided along walking surfaces complying with 403, required at ramps complying with 405, and required at stairs complying with 504 shall comply with 505....
-
1132A.4, Item 4
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
- citEcar Electric Vehicles - ADA Enclosed Passenger Shuttle Wheelchair Ramp
- Public transport. Fixed ramp solution for trains provides wheelchair access, Stepless by Guldmann
-
1011.4, Item 2.2
2.2 “EXIT RAMP DOWN”...
-
1011.4, Item 2.4
2.4 “EXIT RAMP UP”...
-
1013.4, Item 2.2
“EXIT RAMP DOWN”...
-
1013.4, Item 2.4
“EXIT RAMP UP”...