The width of the level area on the side to which the door swings shall extend 18 inches (457 mm) past the strike edge for all doors....
Search Results "Automatic Door"
Filters
Commonly Searched Documents
-
1132A.5.2 Strike edge maneuvering space at doors
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area on the side to which the door swings shall extend 18 inches (457 mm) past the strike edge for all doors....
-
11B-604.8.1.1.2 Maneuvering space with side-opening door
In a wheelchair accessible compartment with a door located in the side wall or partition, either in-swinging or out-swinging, a minimum 60 inches (1524 mm) wide and 60 inches (1524 mm) deep...
-
I. Security
Is the security latch or bolt on the hall door mounted no higher than 48" above the floor so it is within the reach of persons who use wheelchairs and is it operable with one hand, without...
-
g-ii
Is the door hardware (e.g., lever, pull, push, panic bar) usable with one hand, without tight grasping, pinching, or twisting of the wrist, to allow people who may not be able to easily...
-
Remove post (increase clear width at double leaf doors)
[See subsections ...]
-
11B-707.8 Braille instructions
Braille instructions for initiating the speech mode shall be provided. Braille shall comply with Section 11B-703.3.
-
AMTC HYBRIDFLUSH® Sidemount Flushometer
The HYBRIDFLUSH® is a revolutionary full-featured automatic/manual flushometer....
-
Motorized Lift & Slide Door System by Panda
Product by Panda Windows & Doors - Visit www.panda-windows.com for more information!...
-
E. Key Reach Range
If there is key card controlled door hardware on building entrances, is the key card reader positioned so persons who use wheelchairs may approach and operate the opener (48" high maximum...
-
9.5.2(2)(b)
(b) sleeping space for homeless persons as provided in the scoping provisions of 9.1.2 shall include doors to the sleeping area with a minimum clear width of 32 in (815 mm) and maneuvering...
-
Visual Notification Devices
Visual Notification Devices Care must be taken that notification devices intended to signal a door knock or bell are separately wired....
-
D2
Does at least one door or one side of a double leaf-door provide at least 32 inches clear passage width when the door is open 90 degrees?...
-
How To Use the Door Closing Speed Tool
A short tutorial on how to use ETA's Door Closing Speed Tool for compliance surveys in the field. To purchase this tool, visit the Corada Shop....
-
704.3 Volume Control Telephones
An automatic reset shall be provided. Advisory 704.3 Volume Control Telephones. Amplifiers on pay phones are located in the base or the handset or are built into the telephone....
-
704.3 Volume Control Telephones
An automatic reset shall be provided. [ECTCR UFAS 4.31.5] Advisory 704.3 Volume Control Telephones....
-
704.3 Volume Control Telephones
An automatic reset shall be provided. Advisory 704.3 Volume Control Telephones. Amplifiers on pay phones are located in the base or the handset or are built into the telephone....
-
Selectronic Exposed Hard-Wired AC Toilet 1.1 gpf Flush Valve
integral wiper spring prevents clogging and reduces maintenance Fully Mechanical Manual Override - allows valve to flush during a power failure Fail-Safe Operation - valve automatically...
-
Inventory Control Devices
Inventory Control Devices It is important that inventory control or security devices not obstruct required maneuvering clearances at doors....
-
Doorways [4.8.4]
Landings must provide the maneuvering clearance at doors required in ADAAG 4.13. ADAAG allows the landing to overlap maneuvering clearances at doors....
-
707.1 General
Automatic teller machines and fare machines shall comply with 707. Advisory 707.1 General....
-
707.1 General
Automatic teller machines and fare machines shall comply with 707. Advisory 707.1 General....
-
707.1 General
Automatic teller machines and fare machines shall comply with 707. Advisory 707.1 General....
-
§ 38.153 Doors, steps and thresholds
[56 FR 45756, Sept. 6, 1991, as amended at 63 FR 51698, 51702, Sept. 28, 1998]
