Perpendicular to the roadway, the slope of the bus stop boarding and alighting area shall not be steeper than 1:48....
Search Results "Perpendicular Transfer"
Filters
Commonly Searched Documents
-
Slope: ADA Standard Section 810.2.4
-
11B-810.2.4 Slope
Perpendicular to the roadway, the slope of the bus stop boarding and alighting area shall not be steeper than 1:48....
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
-
11B-705.1.2.2.2.1 One entrance/exit point
Where the turning space has one entrance/exit point other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep, as measured perpendicular to the curb, and...
-
11B-809.8.3 Door maneuvering clearance.
At the dwelling unit side of the primary entry doors, secondary exterior doors, and required exit doors maneuvering clearances shall be 44 inches (1118 mm) minimum in length measured perpendicular...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-406.5.6 Grade breaks
Grade breaks at the top and bottom of curb ramp runs shall be perpendicular to the direction of the ramp run....
-
Clear Floor Space [4.16.2]
Space at least 60 inches wide is necessary for side transfers and when provided a 56 inch depth is permitted for either a forward or side approach because of the maneuvering space available...
-
Cross Slope: ADA Standard Section 405.3
Section 405.3 covers the current ADA Standards for cross slope requirements on ramps.
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured perpendicular...
-
Access-Able Designs Tub Transfer Bench SH-414-LR
Stainless steel frame holds up to 250lbs. Rests on tub wall to allow 17-19" height. Folds up easily when not in use. Available with phenolic...
-
Access-Able Designs Tub Transfer Bench SH-414-2SDL
Stainless steel frame holds up to 250lbs. Use this seat with the fold-down legs when there is no inner ledge for the regular seat to rest on. Available with...
-
Openings: ADA Standard Section 302.3
Section 302.3 covers the current ADA Standards for floor and ground surface openings.
-
13. Do the provisions for openings in floor and ground surfaces in Section 302.3 apply to walking surfaces in play areas?
If gratings or openings have elongated openings, they must be placed so the long dimension is perpendicular to the dominant direction of travel....
-
806 Transient Lodging Guest Rooms
806 Transient Lodging Guest Rooms In the NPRM, the Department included floor plans showing examples of accessible guest rooms and bathrooms designs with mobility features to...
-
Lateral grab bar use
(e.g. transferring higher may require usage while transferring lower may not). ...
-
11B-404.2.4.3 Recessed doors and gates
the latch side at an interior doorway, or within 24 inches (610 mm) of the latch side of an exterior doorway, projects more than 8 inches (203 mm) beyond the face of the door, measured perpendicular...
-
EXPERT REVIEW ON THE CURRENT KNOWLEDGE IN TRANSFERS
[See subsections ...]
-
26. Must an employer offer reassignment as a reasonable accommodation if it does not allow any of its employees to transfer from one position to another?
Therefore, an employer who does not normally transfer employees would still have to reassign an employee with a disability, unless it could show that the reassignment caused an undue hardship...
-
Acess-Able Designs Portable Tub/Shower Transfer Bench SH-425
ADA Compliant Stainless steel frame holds up to 350lbs. First commercial-grade portable tub/shower seat on the market. Clamps to tub wall to make...
-
Curb Ramp
Curb ramps can be perpendicular or parallel, or a combination of parallel and perpendicular ramps....
-
Study Limitations
side of the transfer surface....
-
604.3.1 Size
Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular from the rear wall....
-
604.3.1 Size
Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular from the rear wall....
