C204.1 General (Section-by-Section Analysis) This section proposes that, where covered ICT hardware transmits information or has a user interface, such hardware must conform to the applicable...
Search Results "BHMA: Builders Hardware Manufacturers Association"
Commonly Searched Documents
-
C204.1 General (Section-by-Section Analysis)
-
Declaration of Conformity
The United States Telephone Association (USTA) believed that the Board should require a Declaration of Conformity and that it would be wrong to merely regard the Declaration of Conformity...
-
M305.2.3 Height (Section-by-Section Analysis)
Three commenters (a manufacturer, a medical association, and a disability rights organization) did not support the proposal....
- Association for Macular Diseases
-
413.1.1 Caption Controls (Section-by-Section Analysis)
413.1.1 Caption Controls (Section-by-Section Analysis) This proposed section would require that, where video-capable hardware provides physical volume adjustment controls, such ICT must...
-
Compartment: ADA Standard Section 409.4.7.3
Section 409.4.7.3 covers the current ADA Standards for the emergency communication system compartment in private residence elevators.
-
Attachment A: Violations Identified in the United States' Letter of Findings (Sept. 29, 2014)
[See subsections ...]
-
11B-409.3.1 Power operation
Elevator car and hoistway doors and gates shall be power operated and shall comply with ANSI/BHMA A156.19....
-
11B-409.3.1 Power operation
Elevator car and hoistway doors and gates shall be power operated and shall comply with ANSI/BHMA A156.19....
-
11B-409.3.1 Power operation
Elevator car and hoistway doors and gates shall be power operated and shall comply with ANSI/BHMA A156.19....
-
4.1.4. Per Movie Theater Costs
The largest expense associated with this rulemaking for a Megaplex movie theater is purchasing the captioning hardware for each auditorium. ...
-
Guidelines as Minimum Requirements
The Guidelines adopted by the Department provide one way in which a builder or developer may achieve compliance with the Act's accessibility requirements....
-
11B-409.4.7.3 Compartment
If the telephone or device is in a closed compartment, the compartment door hardware shall comply with Section 11B-309....
-
M306.1 General (Section-by-Section Analysis)
Three commenters (a manufacturer, a medical association, and a state agency concerned with accessibility) concurred with the proposed requirement to provide two methods of communication....
-
1.3. Public Comments on Initial Regulatory Assessment and Department Responses
The Department also estimated the average number of auditoriums across each venue type to estimate the number of audio description devices and hardware units needed. ...
-
The Guidelines are not mandatory
The design specifications presented in the Fair Housing Accessibility Guidelines provide technical guidance to builders and developers in complying with the specific accessibility requirements...
-
Department of Justice method
www.usdoj.gov/crt/ada/ckstools.htm) the checklist states that slopes can be measured in three ways: with a land survey to shoot grades, using a digital level, or using a 24 - inch long builders...
-
A. Measuring Slope and Cross Slope
Use a 24" long builders' level and tape measure. Each of these methods will provide the information you need....
- National Braille Association
-
I. Required Survey Tools
The following tools will be required to allow you to accurately complete the ADA Checklist for New Lodging Facilities: A. 12' Stiff Metal Tape Measure B. 24" Long Builders' Level (Square...
- NYC Board of Elections: Video 3 - Accessibility Clerk Responsibilities
-
2. Public Comments on the Initial Regulatory Assessment and Department Responses
The Department also estimated the average number of auditoriums across each venue type to estimate the number of audio description devices and hardware units needed....
-
Attachment J
Provide a door with hardware usable with one hand and without tight grasping, pinching, or twisting of the wrist. ...
-
409.3.1 Power Operation
Elevator car and hoistway doors and gates shall be power operated and shall comply with ANSI/BHMA A156.19 (1997 or 2002 edition) (incorporated by reference, see "Referenced Standards" in...