Do you check exit routes on the back of guest room doors and familiarize yourself with the exits (by tracking the escape route, noting the number of doors between your room and the emergency...
Signs with tactile characters shall comply with 703.4.
Stroke thickness of the uppercase letter “I” shall be 10 percent minimum and 30 percent maximum of the height of the character.
Signs with tactile characters shall comply with Section 11B-703.4.
Stroke thickness of the uppercase letter “I” shall be 10 percent minimum and 20 percent maximum of the height of the character. [2010 ADA Standards] 703.5.7 Stroke Thickness....
practicable to meet the horizontal or vertical requirements of paragraphs (d) (1), (2) or (3) of this section, platform or vehicle devices complying with §38.83(b) or platform or vehicle mounted ramps...
Where exit sign illumination is required by Section 1011.2, the area of refuge sign shall be illuminated....
A manual fire alarm system shall be installed in Group B occupancies having an occupant load of 500 or more persons or more than 100 persons above or below the lowest level of exit discharge...
Where exit sign illumination is required by Section 1003.2.10.4, the area of refuge sign shall be illuminated....
Note that an accessible route through one work area ("research,") may be needed to provide access to an exit as part of an accessible means of egress....
If ramp access is provided to at least 50% of elevated play components and 3 different types of elevated play components can be accessed by a ramp, do any additional ground level accessible...
Suggestion: Install a portable ramp with edge protection and handrails as shown in the figure or relocate the accessible voting to another area that is on an accessible route....
Handrails are required on both sides for ramps with a rise more than 6 inches or a horizontal length more than 72 inches....
[See subsections ...]
[See subsections ...]
5.8.1.2.1 Ramped Entry Slope....
The vertical clearance at doorways with lifts, ramps or bridgeplates shall comply with T502.2....
Doorways at Landings [§405.7.5] Required door maneuvering clearances can overlap ramp landings (it is advisable to locate the swing of doors outside ramp landings for greater safety)....
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
Exterior ramps must be designed so that water does not accumulate on the ramp or landing surface. A slope up to 2% is allowed at landings for adequate drainage....
1.2.7 When local variations (flatness) for cross slope of ramps are measured according to 1.1.14 at least 80% (rounded to the nearest whole number) should not exceed a 2% slope....
to grasp them from outside the vehicle while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches (760 mm) above the ramp...