2.2.1 Coordinators. Airports are required to coordinate efforts to comply with the applicable regulations, including the investigation of complaints alleging its noncompliance with...
Search Results "Seating Plan"
Filters
Commonly Searched Documents
-
2.2 Administrative Requirements.
-
Disability Specific Supplies for Emergency Kits
Edition 2.0, 2016 By June Isaacson Kailes, Disability Policy Consultant and Associate Director Harris Family Center for Disability and Health Policy at Western University of...
-
Brailling Printed Materials
To locate a resource to transcribe printed materials into hardcopy Braille, call local organizations that serve people who are blind or have low vision, independent living centers,...
-
Captioning Audio/Visual Materials
The best way to use captioned audio/visual materials is to purchase or use videos that already have closed captions. If this is not possible or videos must be produced in-house,...
-
M302 Diagnostic Equipment used by Patients in a Seated Position (Section-by-Section Analysis)
M302 in the final rule establishes the technical criteria for diagnostic equipment used by patients in a seated position such as examination chairs....
-
11B-805.7 Built-in cabinets and work surfaces
ETA Editor's Note The Office of Statewide Health Planning and Development (OSHPD), which has jurisdiction over hospitals and long-term care facilities in California, issued Code Application...
-
a) Curb Ramps
Consistent with its Curb Ramp and Sidewalk Transition Plan, the City installs approximately 1,200 new curb ramps each year....
-
Plan 2B: 13-Foot Wide Accessible Guest Room
Plan 2B: 13-Foot Wide Accessible Guest Room This drawing shows an accessible 13-foot wide guest room with features that comply with the 2010 Standards....
-
T605 Seat Belts and Shoulder Belts
[See subsections ...]
-
5.2.2.2 Transfer Surface Depth
The transfer surface should be 17 inches deep minimum for equipment used by patients in a seated position....
-
EMERGENCY PREPAREDNESS AND RECOVERY
If the City of Waukegan contracts with another entity, such as the American Red Cross or another local government, to provide its emergency preparedness plans and emergency response...
-
M302.3.1 Transfer Supports (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed that transfer supports must be provided for use with transfer sides on diagnostic equipment used by patients in the seated position, and that these...
-
A5.1 General
Dining counters (where there is no service) are typically found in small carry-out restaurants, bakeries, or coffee shops and may only be a narrow eating surface attached to a wall....
-
ACCESSMAT® - EN - Beach accessibility mats
AccessMat® is a lightweight and durable 100% polyester roll out matting system specifically developed to create a permanent or temporary route for individuals of all abilities...
-
5.2.2.1 Transfer Surface Width
The transfer surface should be 21 inches wide minimum for examination chairs and other equipment used by patients in a seated position....
-
Figure 802.2.1.1 Lines of Sight Over the Heads of Seated Spectators – Drawing from the U.S. Access Board
-
Figure 802.2.1.2 Lines of Sight Between the Heads of Seated Spectators – Drawing from the U.S. Access Board
-
II-8.2000 Self-evaluation
If structural changes are necessary, they should be included in the transition plan (see II−8.3000). 2) A public entity must review its policies and practices to determine whether any...
-
Service Animals
However, in order to guarantee your seat assignment, you should be aware that, depending on whether the carrier provides advance seat assignments and the type of seating method it uses,...
-
§382.117(b)
(b) You must permit the service animal to accompany the passenger with a disability at any seat in which the passenger sits, unless the animal obstructs an aisle or other area that must...
-
M302.2.2 Size
The size requirements in this section apply only to the portion of the seat used for transfer....
-
221.2.3.1 Horizontal Dispersion
Horizontal dispersion shall not be required in assembly areas with 300 or fewer seats if the companion seats required by 221.3 and wheelchair spaces are located within the 2nd or 3rd quartile...
-
221.2.3.1 Horizontal Dispersion
Horizontal dispersion shall not be required in assembly areas with 300 or fewer seats if the companion seats required by 221.3 and wheelchair spaces are located within the 2nd or 3rd quartile...
-
4.1.6(3)(f)(i)
(i) Where it is technically infeasible to disperse accessible seating throughout an altered assembly area, accessible seating areas may be clustered....
