Video demonstration of how the Norton Surface Mounted 5600 Hands-Free Door Operation Kit works using a rest room door as an example. ...
Search Results "Door Opening Force"
Filters
Commonly Searched Documents
-
Norton Surface Mounted 5600 Hands-Free Door Operation Kits
-
§ 38.25 Doors, steps and thresholds
[See subsections ...]
-
11B-408.3.2.1 Power operation
Swinging doors shall be power-operated and shall comply with ANSI/BHMA A156.19....
-
Are doors or gates to employee work areas required to comply?
Entry doors or gates to employee work areas are required to meet applicable requirements, including those for maneuvering clearance, on the exterior, but not the interior....
-
Gaps
Gaps Where wheelchair spaces are provided on amusement rides, the floors of rides must be coordinated with the floors of the load and unload areas so that when the ride is at...
-
12162(a)(2)(D)(i)
(i) be able to be entered by an individual who uses a wheelchair;
-
§ 38.159(c)(6) Attachment
(6) Attachment. When in use for boarding or alighting, the ramp shall be firmly attached to the vehicle so that it is not subject to displacement when loading or unloading a heavy...
-
R&D Workshop Trim-A-Slab Intro Video
Trim-A-Slab product informational video: The basics of Trim-A-Slab, including what it is, what it does, and where you can buy it. Watch the videos in this series for detailed...
-
R&D Workshop Trim-A-Slab Installation Video
This Trim-A-Slab installation and product informational video gets into the installation of Trim-A-slab itself. It shows how to make crossing joints, and how to avoid a lot of work...
-
Section E: Route from Entrance
. (§402.2) E8 If doors are provided along the route to the voting area, is the clear width of each door opening (one door or one active...
-
Aurora Doors Sliding Barn Door
door is desired....
-
(4) Doors to public and common use areas
The final Guidelines continued to provide that on accessible routes in public and common use areas, and for primary entry doors to covered units, doors that comply with ANSI 4.13 meet the...
-
D4
On the latch, pull side of the door, is there at least 18 inches clearance provided if the door is not automatic or power-operated?...
-
2.2 Entrances
Can the accessible entrance be used independently, or is the door heavy or usually locked? Is the entrance door at least 32 inches wide?...
-
Maneuvering Clearances: ADA Standard Section 404.2.4
Section 404.2.4 covers the current ADA Standards for maneuvering clearances at doors, doorways, and gates.
-
M3
M3. Is the hardware (e.g., lever, pull, etc.) usable with one hand without tight grasping, pinching, or twisting of the wrist? [ADA Standards § 4.13.9] Yes No If No,...
-
307.4 Vertical Clearance
EXCEPTION: Door closers and door stops shall be permitted to be 78 inches (1980 mm) minimum above the finish floor or ground....
-
11B-307.4 Vertical clearance
Exception: Door closers and door stops shall be permitted to be 78 inches (1981 mm) minimum above the finish floor or ground. ...
-
307.4 Vertical Clearance
EXCEPTION: Door closers and door stops shall be permitted to be 78 inches (1980 mm) minimum above the finish floor or ground. Figure 307.4 Vertical Clearance...
-
11B-405.7.5 Doorways
Doors, when fully open, shall not reduce the required ramp landing width by more than 3 inches (76 mm)....
-
11B-405.7.5 Doorways
Doors, when fully open, shall not reduce the required ramp landing width by more than 3 inches (76 mm)....
