Interior and exterior signs identifying permanent rooms and spaces shall comply with Sections 11B-703.1 _|Signs; General|_ 11B-703.2 _|Signs; Raised Characters|_, 11B-703.3 _|Braille|_,...
Search Results "Department of Interior"
-
11B-216.2 Designations
-
11B-216.2 Designations
Interior and exterior signs identifying permanent rooms and spaces shall comply with Sections 11B-703.1 _|Signs; General|_ 11B-703.2 _|Signs; Raised Characters|_, 11B-703.3 _|Braille|_,...
-
Handouts per Gov Code 65941.6
For jurisdictional CASp's what is you department doing to comply with this requirement?...
-
5. Q: Recently a job applicant for a police officer's job came into the police department with fingers that were visibly impaired. The police department required that he demonstrate that he could pull the trigger on the police issue firearm and reload it before a conditional job offer was made. Did this violate the ADA?
A: No. If an individual has a "known" disability that would reasonably appear to interfere with or prevent performance of job functions, that person may be asked to demonstrate how...
-
1009.7.2 Separation
Exterior walls separating the exterior area of assisted rescue from the interior of the building shall have a minimum fire-resistance rating of 1 hour, rated for exposure to fire from the...
-
1009.7.2 Separation
Exterior walls separating the exterior area of assisted rescue from the interior of the building shall have a minimum fire-resistance rating of 1 hour, rated for exposure to fire from the...
-
Signage
Provide directional signage to the interior accessible route between the Museum lobby and the Spy City Café and on the main Café entry door to the exterior accessible Café entrance....
-
22.1 Q. Must the switches on range hood kitchen ventilation fans be in accessible locations?
The Fair Housing Act has no requirements for appliances in the interiors of dwelling units, or the switches that operate them....
-
§382.61(e)
(e) You are not required to retrofit cabin interiors of existing aircraft to comply with the requirements of this section....
-
F228.2 Mail Boxes
Where mail boxes are provided in an interior location, at least 5 percent, but no fewer than one, of each type shall comply with 309....
-
228.2 Mail Boxes
Where mail boxes are provided in an interior location, at least 5 percent, but no fewer than one, of each type shall comply with 309....
-
Entrance
definition of "entrance" has been revised in the final Guidelines to clarify this point, and the term "entry" is used instead of "entrance" when referring to the entry into a unit when it is interior...
-
Maneuvering Clearances [§404.2.4]
Such doors are usually wider to accommodate beds and gurneys, and they are often located close to adjacent interior walls to facilitate circulation and to enhance privacy. ...
-
Taking Photographs
It is a good idea to take several photos of the exterior and interior of the polling place. We recommend taking photographs of measurements and noncompliant elements such as steps....
-
Accessible Route
Interior accessible routes may include corridors, floors, ramps, elevators, lifts, and clear floor space at fixtures....
-
4(6)
units with direct exterior access, outside landing surfaces constructed of impervious materials such as concrete, brick or flagstone, are no more than 1/2 inch below the floor level of the interior...
-
1132A.4, Item 4
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
-
Wheelchair Access
Wheelchair Access A wheelchair accessible public phone is required at all interior and exterior pay phone "banks" (i.e., two or more adjacent phones)....
-
Height: ADA Standard Section 505.4
Section 505.4 covers the current ADA Standards for the height of the top of the gripping surface of handrails.
-
11B-404.2.4.3 Recessed doors and gates
Maneuvering clearances for forward approach shall be provided when any obstruction within 18 inches (457 mm) of the latch side at an interior doorway, or within 24 inches (610 mm) of the...
-
11B-404.2.4.3 Recessed doors and gates
Maneuvering clearances for forward approach shall be provided when any obstruction within 18 inches (457 mm) of the latch side at an interior doorway, or within 24 inches (610 mm) of the...
-
Yale 2100 Series Flatbar Exit Device
Architectural finishes add new dimensions of versatility to the 2100 series, making it a perfect fit for prominent entryways in office buildings, department stores, movie theaters and other...
-
Hager Companies 2300 Series Lever
Hager 2300 Series tubular lockset provides the necessary security and dependability for applications where there is a need for interior functions requiring a residential look and feel...
