Search Results "ACA: Patient Protection and Affordable Care Act"

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.8 Fittings

  Transfer supports shall not rotate within their fittings when in place for transfer.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.7 Clearance

  Clearance between the transfer support gripping surface and adjacent surfaces or obstructions shall be 1 ½ inches (38 mm) minimum.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  18 Inch Low Height

  18 Inch Low Height As our discussions progressed on the low height, whether it should be 17 inches, 18 inches or 19 inches; a compromise position of 18 inches was suggested. Some...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  Height – M301.2.1 & M302.2.1

  Height – M301.2.1 & M302.2.1 The subcommittee discussed the increments for adjustability and decided that infinite adjustability is the appropriate standard as both electronic...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M305.2.3 Fittings

  Transfer supports shall not rotate within their fittings.

• Products and Additional Resources > Products
  Sargent 7800 Mortise Lock with Push/Pull Trim Hardware
  

  The Push/Pull design commonly known for its ease of operation is coupled with the strength and integrity of a mortise lock to provide greater versatility. The PT 7800 is perfect for...

• Federal Documents > Technical Assistance > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment - Example Applications of Proposed Standards
  Figure M2: M301.4 Lift Compatibility

  (at Diagnostic Equipment for Use by a Patient in a Supine, Prone, or Side-Lying Position)...

• Interpretations and Opinions > ETA Interpretations and Opinions > ETA Opinion: Clearances between a handrail and adjacent wall surface
  Clearances between a handrail and wall surface: 2012 NFPA 101 vs. 2010 ADA

  Question/Issue: According to the new 2012 NFPA 101 Life Safety Code, Chapter 7, Section 7.2.2.4.4.5 & Exhibit 7.97, the finger clearance at an existing stair handrail...

• Federal Documents > Regulations > 49 CFR Parts 37 & 38 - Department of Transportation (DOT) ADA Regulations
  § 38.83(b)(5) Platform barriers

  (5) Platform barriers. The lift platform shall be equipped with barriers to prevent any of the wheels of a wheelchair or mobility aid from rolling off the lift during its operation....

• Federal Documents > Regulations > 49 CFR Parts 37 & 38 - Department of Transportation (DOT) ADA Regulations
  § 38.125(b)(5) Platform barriers

  (5) Platform barriers. The lift platform shall be equipped with barriers to prevent any of the wheels of a wheelchair or mobility aid from rolling off the lift during its operation....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.3.1 Permitted Obstructions to Transfer Sides for M301 and M302

  Obstructions shall not be vertically less than 1 inch nor be horizontally more than 3 inches from the edge of the patient support surface to provide unobstructed access to the transfer surface...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4.5.1 Transfer and Positioning Support Position for Imaging Equipment

  5.4.5.1 Transfer and Positioning Support Position for Imaging Equipment. The transfer or positioning support should be oriented horizontally on imaging equipment with transfer...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4.2.2 Transfer and Positioning Support Length for Imaging Equipment with Transfer Surfaces

  5.4.2.2 Transfer and Positioning Support Length for Imaging Equipment with Transfer Surfaces. Transfer supports for imaging equipment should be 28 inches minimum in length and...

• Federal Documents > Standards > 2010 ADA Standards
  General: ADA Standard Section 232.1

  Section 232.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for detention facilities and correctional facilities.

• Federal Documents > Preamble to Regulations > 28 CFR Part 36, Appendix B: Preamble to Regulation on Nondiscrimination on the Basis of Disability by Public Accommodations and in Commercial Facilities (1991 ADA Title III Regulations Preamble)
  Section 36.405 Alterations: Historic Preservation (Section-By-Section Analysis and Response to Comments)

  36.405 Alterations: Historic Preservation (Section-By-Section Analysis and Response to Comments) Section 36.405 gives effect to the intent of Congress, expressed in section 504(c) of the Act...

• State and Local Documents > Guidelines > Accessibility Guidebook for Outdoor Recreation and Trails
  Trailheads

  To comply with the ABA and Section 504 of the Rehabilitation Act of 1973, ensure that each constructed feature provided at a trailhead complies with the applicable provisions of FSORAG and...

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M301.4.1 Clearance in Base (Section-by-Section Analysis)

  the patient bed which makes the under bed clearance impractical and the concern about requiring non-ferrous materials in the MRI room....

• Federal Documents > Standards > 1991 ADA Standards for Accessible Design
  4.1.7(2)(b) Alterations to Qualified Historic Buildings and Facilities Not Subject to Section 106 of the National Historic Preservation Act

  (b) Alterations to Qualified Historic Buildings and Facilities Not Subject to Section 106 of the National Historic Preservation Act....

• Additional Access Publications > Accessible Health Care Briefs: HEALTH CARE (Clinic/Outpatient) FACILITIES ACCESS
  2. b. WIDE AND EASY­ TO­ OPEN EXTERIOR AND INTERIOR DOORS

  [See subsections ...]

• Additional Access Publications > Accessible Health Care Briefs: HEALTH CARE (Clinic/Outpatient) FACILITIES ACCESS
  2. a. iii. Clear (Path-of-Travel) Floor Space

  Access also includes how people will move into and around lobby and office reception areas, and determine the unobstructed floor or ground space to accommodate a wheelchair user....

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.1 Location

  Transfer supports shall comply with M305.2.1.1 or M305.2.1.2 and shall be located 1 ½ inches (38 mm) maximum measured horizontally from the plane defined by the nearest edge of the...

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.4 Cross Section

  Transfer supports shall have a cross section complying with 305.2.4.1 or 305.2.4.2.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.3 Height

  During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed...

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.6 Gripping Surface

  Transfer support gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides. The bottoms of transfer support gripping surfaces...