Between 9 inches (230 mm) and 27 inches (685 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
Search Results "Sink Depth"
Filters
Commonly Searched Documents
-
306.3.4 Clearance Reduction
-
Seat [4.21.3]
The seat must extend the full depth of the transfer stall to help minimize the gap between the seat and a wheelchair. Folding seats can be used....
-
505.10.3 Bottom Extension at Stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
Diversified Woodcrafts ADA Instructor's Desk 1214K-L-ADA
This unit has a roll-under sink with paddle handle faucet and gas fixture. The knee space is wide enough for a wheel chair to fit into the space. The 34" H meets ADA requirements....
-
Diversified Woodcrafts ADA Instructor's Desk 1216K-L-ADA
This unit has a roll-under sink with paddle handle faucet and gas fixture. The knee space is wide enough for a wheel chair to fit into the space. The 34" H meets ADA requirements....
-
1009.5.1 Transfer Platform
Transfer platforms shall provide 19 inches (485 mm) minimum clear depth and 24 inches (610 mm) minimum clear width. Figure 1009.5.1 Size of Transfer Platform...
-
11B-1009.5.6 Size
Each transfer step shall have a tread clear depth of 14 inches (356 mm) minimum and 17 inches (432 mm) maximum and shall have a tread clear width of 24 inches (610 mm) minimum....
-
R408.2 Treads and Risers
All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 100 mm (4 in) high minimum and 180 mm (7 in) high maximum....
-
Single-User Toilet Rooms: Side Transfer Space
In-swinging doors clearing fixture clearances usually determine the minimum room depth....
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where it is technically infeasible to provide a minimum 108 inches (2743 mm) wide turning space, as measured perpendicular to the curb, the depth of detectable warnings may be reduced to...
-
11B-705.2 Detectable directional texture
The depth of the texture shall not be less than 36 inches (914 mm)....
-
1009.5.6 Size
Each transfer step shall have a tread clear depth of 14 inches (355 mm) minimum and 17 inches (430 mm) maximum and shall have a tread clear width of 24 inches (610 mm) minimum....
-
3(2)
Openings more than 24 inches in depth are not considered doorways. (See Fig. 1(d).)...
-
11B-505.10.3 Bottom extension at stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance equal to one tread depth beyond the last riser nosing....
-
1. Desk size
To provide adequate knee and leg clearance, desks and writing tables need to have at least 30 inches of knee width, 29 inches of knee height, and 19 inches of leg depth....
-
1018.4 Clear Width
Beach wheelchairs have large, wide wheels that can roll across sand without sinking....
-
Current Accessibility Guidelines That Apply to the Forest Service
The Forest Service and those working with or for the Forest Service on National Forest System land must comply with the following enforceable guidelines and standards when designing,...
-
Wading Pools
Wading Pools A wading pool is a pool designed for shallow depth and is used for wading. Each wading pool must provide at least one sloped entry into the deepest part....
-
R409.10.3 Bottom Extension at Stairways
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
Meeting the Challenge, Inc.
Through information dissemination, training, and direct technical assistance and in depth consulting service, we have pursued this focus for over 24 years....
-
505.10.3 Bottom Extension at Stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
M302.2 Transfer Surface
Transfer Surface M302.2.3 Transfer Sides Proposed requirement: The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth...
-
M303.2.4 Knee and Toe Clearance
The depth of the wheelchair space shall include knee and toe clearance of 17 inches (430 mm) minimum and 25 inches (635 mm) maximum....
-
4.4 Knee and Toe Clearances
Knee Clearance Height (KCH) 685 640-650 680 700 Knee Clearance Depth (KCDL) 280...
