Where not all picnic units are accessible, the picnic units that are accessible shall not be identified by signs at the individual units. Information on the location of accessible...
Search Results "Non-Fixed Element"
Filters
Commonly Searched Documents
-
3.3.3 Identification of Accessible Picnic Units
-
4.24.6 EXPOSED PIPES AND SURFACES
Hot water and drain pipes exposed under sinks shall be insulated or otherwise covered. There shall be no sharp or abrasive surfaces under sinks.
-
F212.3 Sinks
* * * * * EXCEPTIONS: * * * * * 2. In camping facilities and picnic facilities, sinks shall not be required to comply with F212.3 where a cooktop or conventional range is not...
-
11B-608.3.2 Standard roll-in type shower compartments
11B-608.3.2 Standard roll-in type shower compartments. Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the...
-
Guestrooms with Roll-in Showers
Guestrooms with Roll-in Showers Common Problem: In hotels, motels, or other lodging facilities of 50 or more sleeping rooms, no rooms with roll-in showers are provided, or the...
-
11B-606.7 Sink depth
11B-606.7 Sink depth. Where a forward approach is required at a sink, knee and toe clearance shall be provided in compliance with Section 11B-306.
-
11B-606.1 General
11B-606.1 General. Lavatories and sinks shall comply with Section 11B-606. [2010 ADAS] Advisory 606.1 General. If soap and towel dispensers are provided, they must be located...
-
11B-809.4.1 Subsequent bathrooms
In residential dwelling units with more than one bathroom, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.4 and a shower compartment is provided...
-
11B-809.4.1 Subsequent bathrooms
In residential dwelling units with more than one bathroom, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.4 and a shower compartment is provided...
-
11B-606.7 Sink depth
Where a forward approach is required at a sink, knee and toe clearance shall be provided in compliance with Section 11B-306.
-
11B-606.1 General
Lavatories and sinks shall comply with Section 11B-606. Advisory 11B-606.1 General. If soap and towel dispensers are provided, they must be located within the reach ranges...
-
11B-608.3.2 Standard roll-in type shower compartments
Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the seat. Grab bars shall be installed 6 inches (152 mm)...
-
F. Chapter 5: Doorways, Circulation Paths, and Fare Collection Devices
Chapter 5 in the 2016 Non-Rail Vehicle Guidelines contains the technical requirements for doorways, illumination at doorways and boarding and alighting areas, passenger access routes, and...
-
4.30.5* Finish and Contrast
The characters and background of signs shall be eggshell, matte, or other non-glare finish....
-
Guest Rooms with Mobility Features: ADA Standard Section 224.2
Section 224.2 covers scoping requirements in the current ADA Standards for transient lodging guest rooms with mobility features.
-
13.1 Q. Are the public and common use areas of a newly constructed development that consists entirely of buildings having four or more multistory townhouses, with no elevators, required to be accessible?
A. No. The Fair Housing Act applies only to new construction of covered multifamily dwellings. Multistory townhouses, provided that they meet the definition of multistory in the...
-
Pictograms and Symbols of Accessibility [ADA Standards §216.2 , §703.6, §703.7]
Pictograms and Symbols of Accessibility [ADA Standards §216.2 , §703.6, §703.7] Where pictograms are provided to identify a permanent room or space, such as a stairway, they...
-
11B-233.3.1.2 Residential dwelling units with adaptable features
ETA Editor's Note This section of the 2019 California Building Code was amended by the Division of the State Architect. The requirements in this section were previously found in...
-
1134A.7 Water closets
In locations where water closets are adjacent to non-grab bar walls, vanities, lavatories or bathtubs, the centerline of the fixture shall be a minimum of 18 inches (457 mm) from the obstacle...
-
12.1 Q...How is the individual building test performed for additional stories, to determine if those stories must also be treated as ground floors?
For purposes of determining whether a non-elevator building has more than one ground floor, the point of measurement for additional ground floors, after the first ground floor has been established...
-
F201.3 Temporary and Permanent Structures
Temporary buildings or facilities covered by these requirements include, but are not limited to, reviewing stands, temporary classrooms, bleacher areas, stages, platforms and daises, fixed...
-
201.3 Temporary and Permanent Structures
Temporary buildings or facilities covered by these requirements include, but are not limited to, reviewing stands, temporary classrooms, bleacher areas, stages, platforms and daises, fixed...
-
11B-902.3 Height
The tops of dining surfaces and work surfaces shall be 28 inches (711 mm) minimum and 34 inches (864 mm) maximum above the finish floor or ground.
-
902.3 Height
The tops of dining surfaces and work surfaces shall be 28 inches (710 mm) minimum and 34 inches (865 mm) maximum above the finish floor or ground.