Kee Access fittings are used to construct ADA and smooth surface railings
Search Results "Modular Ramp"
Commonly Searched Documents
- Simplified Building Kee Access ADA Railings
 - 
    
  
  1132A.4, Item 3
  
Changes in height greater than ½ inch (12.7 mm) shall be accomplished by means of a ramp complying with Section 1114A or by means of a platform constructed to the level of the floor as illustrated...
 - 
    
  
  505.4 Height
  
Top of gripping surfaces of handrails shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
 - 
    
  
  4.1.6(1)(f)
  
(f) If an escalator or stair is planned or installed where none existed previously and major structural modifications are necessary for such installation, then a means of accessible...
 - 
    
  
  1131A.2 Changes greater than ½ inch
  
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
 - 
    
  
  1131A.2 Changes greater than ½ inch
  
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
 - 
    
  
  Accessible Routes on the Playing Surface
  
Where ramps change direction, the landing size must be a minimum of 48 inches by 60 inches....
 - 
    
  
  1131A.2 Changes greater than ½ inch
  
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
 - 
    
  
  Cross Slope and Surfaces [4.8.6]
  
Ramp surfaces must comply with requirements for ground and floor surfaces and be "stable, firm, and slip-resistant." A specific level of slip-resistance is not mandated....
 - 
    
  
  5.9.2 Standing Supports on Ramped Entry Raised Platforms with Wheelchair Spaces
  
5.9.2 Standing Supports on Ramped Entry Raised Platforms with Wheelchair Spaces....
 - citEcar ADA Electric Shuttle 11P 1WC
 - citEcar ADA Enclosed Shuttle 11P 1WC
 - 
    
  
  5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations
  
5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations The Committee recommends a two-inch high edge protection on the back of the platform...
 - 
    
  
  Problem Three (Accessible Route)
  
Solution: Install a portable ramp....
 - 
    
  
  11B-505.9 Fittings
  
Handrails shall not rotate within their fittings.
 - 
    
  
  505.9 Fittings
  
Handrails shall not rotate within their fittings.
 - 
    
  
  505.9 Fittings
  
Handrails shall not rotate within their fittings.
 - 
    
  
  505.9 Fittings
  
505.9 Fittings. Handrails shall not rotate within their fittings.
 - 
    
  
  § 36.304(b)(2)
  
(2) Making curb cuts in sidewalks and entrances;
 - 
    
  
  Sec.36.304(b)(2)
  
(2) Making curb cuts in sidewalks and entrances;
 - 
    
  
  4.8.4(4)
  
(4) If a doorway is located at a landing, then the area in front of the doorway shall comply with 4.13.6.
 - 
    
  
  505.9 Fittings
  
Handrails shall not rotate within their fittings.
 - 
    
  
  Transition to Street [§406.2]
  
Transition to Street [§406.2]
 - 
    
  
  11B-505.9 Fittings
  
Handrails shall not rotate within their fittings.