Other than the door to the accessible water closet compartment, a door in any position, may encroach into the turning space by 12 inches (305 mm) maximum....
Search Results "Compartment Door"
Filters
Commonly Searched Documents
-
11B-603.2.3 Door swing
-
T502.4 Doorways with Steps on Over-the-Road Buses
The door opening clear width above a height of 48 inches (1220 mm) measured from the lowest step tread shall be permitted to taper so as to reduce in width to 18 inches (457 mm) minimum....
-
Thresholds at Exterior Doors/Thresholds to Balconies or Decks
Additionally, the final Guidelines provide that at the primary entry doors to dwelling units with direct exterior access, outside landing surfaces constructed of impervious materials such...
-
Doug Mockett & Company SDH1 Sliding Door Hardware
This is an installation video for the Doug Mockett & Company SDH1 Sliding Door Hardware....
-
ASI Global Partitions Plastic Laminate Partitions
Door Hinges Special driver installs fasteners which virtually eliminates unauthorized removal and ensures easy installation....
-
4.1.3(7)(c)
(c) Each door that is an element of an accessible route shall comply with 4.13....
-
4.1.3(7)(d)
(d) Each door required by 4.3.10, Egress, shall comply with 4.13....
-
Minimum Clear Opening
The issue of minimum clear opening for doors was one of the most widely commented-upon design features of the guidelines....
-
(3) Doors within individual dwelling units
The final Guidelines recommend that doors intended for user passage within individual dwelling units have a clear opening of at least 32 inches nominal width when the door is open 90 degrees...
-
11B-809.10.6.2 Slope
The slope of the shower floor shall be 1/2 inch (12.7 mm) per foot maximum in any direction and shall slope to a drain. The floor surfaces shall be of Carborundum, grit-faced tile or...
-
11B-809.10.6.6 Controls
Controls and operating mechanisms shall comply with Section 11B-309.4.
-
2.3 Restrooms
Is the entry door at least 32 inches wide?...
-
Adjusting the Hager Companies 5100 Door Closer
Learn how to adjust a Hager Companies 5100 door closer....
-
4.1.3(7)(b)
(b) Within a building or facility, at least one door at each accessible space shall comply with 4.13....
-
11B-809.4.1 Subsequent bathrooms
In residential dwelling units with more than one bathroom, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.4 and a shower compartment is provided in...
-
Jacknob Corp. 6069 ADA Latch & Slide Partition Hardware with "Occupied" Indicator
6069 Latch-Slide-"occupied" ADA - CRSS 119689 Latch-Slide-(6069) "occupied"-3/4 Door - For 3/4" Thick Doors #117749 (For 7/8" Thick Doors) #6069 (For 1" Thick Doors) Satin Stainless...
-
Can maneuvering for a forward approach be provided when there is space at least 60” deep in front of a door?
Space at least 60” deep in front of a door that is unobstructed on approach sides will provide sufficient depth for a forward approach if appropriate strike-side clearance is provided; but...
-
Car Dimensions: ADA Standard Section 407.4.1
Section 407.4.1 covers the current ADA Standards for elevator car dimensions.
-
11B-809.4.1 Subsequent bathrooms
In residential dwelling units with more than one bathroom, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.4 and a shower compartment is provided in...
-
11B-809.4.1 Subsequent bathrooms
In residential dwelling units with more than one bathroom, when a bathtub is installed in the first bathroom in compliance with Section 11B-809.4 and a shower compartment is provided in...
-
ASI Global Partitions High Density Polyethylene Solid Plastic Toilet Partitions
Vandal-Resistant Fasteners Special driver installs fasteners which virtually eliminates unauthorized removal and ensures easy installation. 55” High Doors and Panels 14” clearance from...
-
11B-411.3.5 Width
The width of elevator doors shall comply with Table 11B-407.4.1....
-
6.3(5)
(5) Each bedroom shall have a door that complies with 4.13....
-
11B-411.3.5 Width
The width of elevator doors shall comply with Table 11B-407.4.1....
