The supporting construction shall be protected to afford the required fire-resistance rating of the wall or floor supported in buildings of other than Type IIB, IIIB or VB construction....
Search Results "Back Support"
-
709.4 Continuity
-
Wiring for Visible Alarms [§215.3]
Wiring for Visible Alarms [§215.3] All employee work areas served by audible fire alarms, regardless of size, must be designed to support later installation of visible alarms after...
-
3306.2 Walkways
Walkways shall be accessible in accordance with Chapter 11A or 11B as applicable, and shall be designed to support all imposed loads, and the design live load shall be not less than 150...
-
3306.2 Walkways
Walkways shall be accessible in accordance with Chapter 11A or 11B as applicable, and shall be designed to support all imposed loads, and the design live load shall be not less than 150...
-
Transfer Surface Height (M301.2.1 and M302.2.1)
Patient support surfaces can be adjusted to heights outside the specified dimensions when not needed for patient transfer such as when performing diagnostic procedures....
-
Design Criteria for the Transfer Station
The station was designed to investigate the impact handhelds, back rests, heights, and seat widths have on transfer performance....
-
Station 2-Three-Point Turn
A three-point turn is defined as a maneuver where the user starts at one edge of the shared use path, makes a forward turn toward the other side of the path, backs up while turning the device...
-
407.4.1 Car Dimensions
Dimensions Minimum Dimensions Door Location Door Clear Width Inside Car, Side to Side Inside Car, Back...
-
Sec.36.603(b)(2)
(2) Copies of the proposed request and supporting materials are made available for public examination and copying at the office of the State or local agency charged with administration and...
- Landscape Forms Inc. Austin Trash Receptacle
-
11B-708.4.2 Residential dwelling unit interface
The residential dwelling unit system interface shall include a telephone jack capable of supporting voice and TTY communication with the common use or public use system interface....
-
708.4.2 Residential Dwelling Unit Interface
The residential dwelling unit system interface shall include a telephone jack capable of supporting voice and TTY communication with the common use or public use system interface....
-
Midmark Corporation
Midmark Corporation RECOMMENDATION OF ALIGNING TRANSFER SUPPORT WEIGHT REQUIREMENTS WITH BIFMA STANDARDS SEPTEMBER 27, 2013 SUBMITTED BY: Midmark Corporation (Bob Menke, committee...
-
11B-708.4.2 Residential dwelling unit interface
The residential dwelling unit system interface shall include a telephone jack capable of supporting voice and TTY communication with the common use or public use system interface....
-
708.4.2 Residential Dwelling Unit Interface
The residential dwelling unit system interface shall include a telephone jack capable of supporting voice and TTY communication with the common use or public use system interface....
- Steelcase Ology Series Height-Adjustable Table
-
Transfer Surface Size: Equipment Used by Patients in Supine, Prone, or Side-Lying Position (M301.2.2)
As noted earlier, the technical criteria do not address the overall width and depth of patient support surfaces because of the diverse shape and size of these surfaces....
-
5.2.3 Transfer Surface Measurement Recommendation for M301 and M302
The transfer surface dimensions do not include headrests, footrests, or similar supports for body extremities that do not support the patient’s overall body position....
-
§ 1194.23(k)(3)
(3) If key repeat is supported, the delay before repeat shall be adjustable to at least 2 seconds. Key repeat rate shall be adjustable to 2 seconds per character....
-
§ 1194.31(e)
(e) At least one mode of operation and information retrieval that does not require user speech shall be provided, or support for assistive technology used by people with disabilities shall...
-
§ 1194.23(b)
(b) Telecommunications products which include voice communication functionality shall support all commonly used cross-manufacturer non-proprietary standard TTY signal protocols....
-
E208.1 General (Section-by-Section Analysis)
E208.1 General (Section-by-Section Analysis) This section proposes to require agencies, when providing support services or documentation for ICT, to do so in conformance to the provisions...
-
§100.500(d) Relationship to discriminatory intent
A demonstration that a practice is supported by a legally sufficient justification, as defined in paragraph (b) of this section, may not be used as a defense against a claim of intentional...