Installation guide for the DH2 Door Handle, including Single-Sided and Back to Back Mounting installations. ...
Search Results "Automatic Door"
Filters
Commonly Searched Documents
-
Mockett DH2 Door Handle Installation
-
Input Controls: ADA Standard Section 707.6.1
At least one tactilely discernible input control shall be provided for each function. Where provided, key surfaces not on active areas of display screens, shall be raised above...
-
11B-707.6.1 Input controls
At least one tactilely discernible input control shall be provided for each function. Where provided, key surfaces not on active areas of display screens, shall be raised above...
-
1132A.4.1 Thresholds
Thresholds at the primary entry and required exit doors shall be no higher than ½ inch (12.7 mm)....
-
1132A.4.1 Thresholds
Thresholds at the primary entry and required exit doors shall be no higher than ½ inch (12.7 mm)....
-
6.3(1)
(1) Each bedroom shall have a door that complies with 4.13....
-
11B-404.2.4 Maneuvering clearances
Minimum maneuvering clearances at doors and gates shall comply with Section 11B-404.2.4....
-
4.13.2 Revolving Doors and Turnstiles
Revolving doors or turnstiles shall not be the only means of passage at an accessible entrance or along an accessible route....
-
4.13.2 REVOLVING DOORS AND TURNSTILES
Revolving doors or turnstiles shall not be the only means of passage at an accessible entrance or along an accessible route....
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
-
Door Opening Force
Door Opening Force If you’re using a door pressure gauge, place it where you would push open the door. ...
-
Clear With [sic] [§404.2.3]
Clear With [sic] [§404.2.3] The clear width is measured from the stop to the face of doors or gates open 90⁰ (or to the leading edge of sliding or folding doors....
-
11B-220.1.3 Three or more automatic teller machines or fare machines
Where three or more automatic teller machines or fare machines are provided at a location, at least 50 percent shall comply with Sections 11B-707.2 through 11B-707.8 and the rest shall comply...
-
11B-220.1.3 Three or more automatic teller machines or fare machines
Where three or more automatic teller machines or fare machines are provided at a location, at least 50 percent shall comply with Sections 11B-707.2 through 11B-707.8 and the rest shall comply...
-
11B-233.3.1.2.6.5 Additional requirements.
Interior door opening width complying with Section 11B-404.3.1. 3. Door and gate hardware complying with Section 11B-404.2.7. 4....
-
11B-220.1.3 Three or more automatic teller machines or fare machines
Where three or more automatic teller machines or fare machines are provided at a location, at least 50 percent shall comply with Sections 11B-707.2 through 11B-707.8 and the rest shall comply...
-
402.3.2 Non-private Listening
A function shall be provided to automatically reset the volume to the default level after every use....
-
Thresholds at Exterior Doors/Thresholds to Balconies or Decks
Additionally, the final Guidelines provide that at the primary entry doors to dwelling units with direct exterior access, outside landing surfaces constructed of impervious materials such...
-
T502.4 Doorways with Steps on Over-the-Road Buses
The door opening clear width above a height of 48 inches (1220 mm) measured from the lowest step tread shall be permitted to taper so as to reduce in width to 18 inches (457 mm) minimum....
-
Visitability
— The three essential features are one entrance with zero steps; 32 inches or more of clear passage space through interior doors, including bathrooms; and at least a half bathroom on...
-
(3) Doors within individual dwelling units
The final Guidelines recommend that doors intended for user passage within individual dwelling units have a clear opening of at least 32 inches nominal width when the door is open 90 degrees...
-
M-Power Flush Valve Features and Benefits
Discover the features and benefits of M-Power Flush Valves.
-
Programming Flush Volume on M-Power Flush Valves
Learn how to program the flush volume on M-Power Flush Valves.
-
Minimum Clear Opening
The issue of minimum clear opening for doors was one of the most widely commented-upon design features of the guidelines....
