Beach access routes are required when an entity that administers or manages a beach constructs or alters any circulation paths, parking facilities, toilet facilities, or bathing...
Search Results "Side Grab Bar"
Filters
Commonly Searched Documents
-
Facilities Serving Beaches [F248.1.1]
-
Beach Nourishment [F248.1.2]
Beach access routes are required when the entity that administers or manages the beach undertakes a beach nourishment project. The entity is not required to spend more than 20...
-
Openings [1018.6]
Openings are gaps in the surface of a beach access route. Gaps, including spaces between the planks on a boardwalk and drainage holes in temporary or permanent surfaces, that are...
-
1018.7 Slopes
This section contains technical requirements for the maximum running slope and segment length (1018.7.1) and cross slope (1018.7.2) of beach access routes.
-
Openings in Beach Access Routes
Openings are gaps in the surface of a beach access route. Gaps include spaces between the planks on a boardwalk and drainage holes in temporary or permanent surfaces. Openings that...
-
6.7 Slope
The slopes of beach access routes shall comply with 6.7.1 and 6.7.2
-
6.10 Openings
Openings in the surface of beach access routes and their related resting intervals may be up to 1/2 inch (13 millimeters) wide. Where possible, elongated openings should be...
-
6.14 Gates and Barriers
Where gates or barriers are constructed to control access to beach access routes, gates and barriers shall comply with 6.14.
-
6.7.1.1
The grade of a Beach Access Route shall be 1:20 (5 percent) or less for any distance.
-
Beach Nourishment
A process by which sediment (usually sand) is added to a beach. An entity is not required to expend more than 20% of the costs of a beach nourishment project to provide a beach...
-
6.7.1 Running Slope (Grade)
The running slope (grade) of a Beach Access Route shall comply with all applicable provisions of this section. Table 6.7.1. Running Slope (Grade) and Resting...
-
1018.7 Slopes
The slopes of beach access routes shall comply with 1018.7.
-
1018.6 Openings
Openings in the surface of beach access routes and resting intervals shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1018.6 Openings....
-
F248.1 General
Beach access routes complying with 1018 shall be provided in accordance with F248.1. Beach access routes shall be permanent or removable. EXCEPTION: Beach access routes shall not...
-
Figure 404.2.4.1(a) Maneuvering Clearances at Manual Swinging Doors and Gates: Front Approach, Pull Side – Drawing from the U.S. Access Board
-
Figure 404.2.4.1(b) Maneuvering Clearances at Manual Swinging Doors and Gates: Front Approach, Push Side – Drawing from the U.S. Access Board
-
1607.9 Loads on handrails, guards, grab bars, shower seats, dressing room bench and seats
1607.9 Loads on handrails, guards, grab bars, shower seats, dressing room bench and seats....
-
Figure 404.2.4.1(c) Maneuvering Clearances at Manual Swinging Doors and Gates: Front Approach, Push Side with Closer and Latch – Drawing from the U.S. Access Board
-
§100.205(d)
(d) The application of paragraph (c) of this section may be illustrated by the following examples: Example (1): A developer plans to construct a 100 unit condominium apartment...
-
4.34.5.5 SHOWERS
If a shower is provided, it shall have the following features:
-
406.5 Location
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
-
11B-233.3.1.2.6.5 Additional requirements.
Grab bar reinforcement complying with Sections 11B-809.10.5.2, 11B-809.10.6.4, or 11B-809.10.7.3. 2. Interior door opening width complying with Section 11B-404.3.1. 3....
-
11B-406.5.10 Diagonal curb ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....
-
M301 Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position; M302 Diagnostic Equipment Used by Patients in Seated Position
M301 provides technical criteria for diagnostic equipment used by patients in a supine, prone, or sidelying position, and M302 provides technical criteria for diagnostic equipment used by...
