Electrical or communication receptacles serving a dedicated use shall not be required to comply with 309. 3....
Search Results "ANSI/IEEE: American National Standards Institute/ Institute of Electrical and Electronics Engineers"
Filters
Commonly Searched Documents
-
205.1 General
-
7. Commit to Ongoing Maintenance of Accessible Playground Surfaces as a Responsibility of Ownership
Each of the 16 participating municipalities had maintenance personnel trained through either the National Recreation and Park Association’s Certified Playground Safety Inspector program...
-
205 Operable Parts, F205 Operable Parts
Exception 3 (Electrical Outlets in Kitchen) Where two or more electrical outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance,...
-
III. Benefits of Ratification
Many of these products are engineered, made, or sold by U.S. corporations, who will benefit from an active U.S. presence to reach this emerging new source of revenue....
-
Lutron Caséta Wireless Dimmers and Switches
Control your lights, shades and temperature from anywhere – whether you’re home or away. Caséta Wireless dimmers and switches install in minutes, work with numerous bulb types –...
-
If a state or local authority interprets an accessibility requirement differently than how a comparable requirement in the ADA Standards is interpreted under the ADA (or waives that requirement completely), does this have any bearing on ADA compliance?
may interpret or waive their own state or local accessibility codes as they see fit, those decisions have no effect on the obligation to comply with requirements of the applicable ADA Standards...
-
Assessment factors. (Section-by-Section Analysis)
concerns they did not offer the same level of support if the device were an off-highway vehicle, all-terrain vehicle (ATV), golf car, or other device with a fuel-powered or combustion engine...
-
1136A.2 Switch and control heights
1136A.2 Switch and control heights. Controls or switches intended to be used by the occupant of the room or area to control lighting and receptacle outlets, appliances, alarms or...
-
1136A.2 Switch and control heights
Controls or switches intended to be used by the occupant of the room or area to control lighting and receptacle outlets, appliances, alarms or cooling, heating and ventilating...
-
11B-812.5.1 Accessible route to building or facility
EVCS complying with Section 11B-812 that serve a particular building or facility shall be located on an accessible route to an entrance complying with Section 11B-206.4. Where EVCS...
-
11B-228.3.1.1 Existing facilities
Where new EVCS are added to a facility with existing EVCS, the requirements of Section 11B-812 shall apply only to the new EVCS installed. Alterations to existing EVCS shall comply...
-
1136A.2 Switch and control heights
Controls or switches intended to be used by the occupant of the room or area to control lighting and receptacle outlets, appliances, alarms or cooling, heating and ventilating...
-
11B-812.5.1 Accessible route to building or facility
EVCS complying with Section 11B-812 that serve a particular building or facility shall be located on an accessible route to an entrance complying with Section 11B-206.4. Where EVCS...
-
11B-228.3.1.1 Existing facilities
Where new EVCS are added to a facility with existing EVCS, the requirements of Section 11B-812 shall apply only to the new EVCS installed. Alterations to existing EVCS shall comply...
-
11B-205.1 General
Electrical or communication receptacles serving a dedicated use shall not be required to comply with Section 11B-309. 3. Reserved. [2010 ADAS] 3. ...
-
11B-205.1 General
Electrical or communication receptacles serving a dedicated use shall not be required to comply with Section 11B-309. 3. Reserved. [2010 ADAS] 3. ...
-
11B-706.2 Receiver jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
706.2 Receiver Jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
11B-706.2 Receiver jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
Settlement Agreement Between the United States of America, Louisiana Tech University, and the Board of Supervisors for the University of Louisiana System Under the Americans with Disabilities Act
SETTLEMENT AGREEMENT BETWEEN THE UNITED STATES OF AMERICA, LOUISIANA TECH UNIVERSITY, AND THE BOARD OF SUPERVISORS FOR THE UNIVERSITY OF LOUISIANA SYSTEM UNDER THE AMERICANS WITH DISABILITIES...
-
706.2 Receiver Jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack. [ECTCR UFAS 4.33.7]...
-
706.2 Receiver Jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
11B-706.2 Receiver jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
