All dimensions are subject to conventional building industry tolerances for field conditions....
Search Results "Loading Condition"
Filters
Commonly Searched Documents
-
3.2 Dimensional Tolerances
-
3.2 DIMENSIONAL TOLERANCES
All dimensions are subject to conventional building industry tolerances for field conditions....
-
4.1.2(14)
(14) Tactile warnings shall be provided at hazardous conditions as specified in 4.29.3....
-
§ 38.4(d)(2)
(2) If or if * * * then denotes a specification that applies only when the conditions described are present....
-
T603 Wheelchair Securement Systems
The technical requirements in the 2016 Non-Rail Vehicle Guidelines for wheelchair securement systems include provisions on orientation, design load, movement, and rear-facing wheelchair...
-
§382.21(a)(3)
(3) Impose on the passenger any condition, restriction, or requirement not imposed on other passengers; or...
-
Built-up Curb Ramps [4.7.6]
Built-up curb ramps are permitted where they do not project into vehicular traffic lanes or access aisles at parking spaces and passenger loading zones....
-
III-5.4300 Transportation terminals
If, however, all passenger services in a two-story facility - including boarding, debarking, loading and unloading, baggage claim, dining facilities, and other common areas open to the public...
-
2.3 Clear Tread Width
Where a condition for an exception in section 1.1 prevents achieving the required width, the clear tread width may be reduced to 32 inches (815 mm) minimum....
-
PEMKO 2" to 48" Aluminum Plates No. 18/1
Cover Plate Assemblies are available for use whenever an unusual floor condition occurs....
-
M101.6 Dimensional Tolerances
Dimensions are subject to conventional industry tolerances for manufacturing processes, material properties, and field conditions....
-
IF, IF . . . THEN
[DSA-AC] The terms “if” and “if … then” denotes a specification that applies only when the conditions described are present....
-
M101.5 Dimensional Tolerances
Dimensions are subject to conventional industry tolerances for manufacturing processes, material properties, and field conditions...
-
IF, IF . . . THEN
[DSA-AC] The terms “if” and “if … then” denote a specification that applies only when the conditions described are present....
-
IF, IF . . . THEN
[DSA-AC] The terms “if” and “if … then” denote a specification that applies only when the conditions described are present....
-
4. Flexible Leave Policies
for a number of reasons related to their disability, such as: medical treatment related to the disability; repair of a prosthesis or equipment; temporary adverse conditions...
-
Opening Force [§404.2.9]
Opening Force of Exterior Doors The opening force of exterior swing doors is impacted by wind loading and other exterior conditions, gasketing, HVAC systems, energy efficiency, and...
-
(4) Adjustability: Method of Measurement
The Access Board sought comment in question 13 in the MDE NPRM preamble, on whether the measurement should be taken with the upholstery in static (uncompressed) conditions, or with a certain...
-
1991 ADA Standards
All dimensions are subject to conventional building industry tolerances for field conditions....
-
§8.13(d)(2)
(2) First aid and safety personnel may be informed if the condition might require emergency treatment; and...
-
§ 36.302(f)(1)(ii)(E)
(E) Under the same terms and conditions as other tickets sold for the same event or series of events....
-
Impracticable
Impracticable—In this guidebook, impracticable means work that cannot be completed within the limits of the applicable conditions for an exception....
-
§100.10(c)(1)
(1) The sale or rental of any single family house by an owner, provided the following conditions are met:...
