Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
Search Results "ANSI/IEEE: American National Standards Institute/ Institute of Electrical and Electronics Engineers"
Filters
Commonly Searched Documents
-
Ground Surfaces: ADA Standard Section 1008.2.6
-
FAQ: How do I access the 2010 ADA Standards?
To access the 2010 ADA Standards: 1. From the home page, click on the "2010 ADA Standards" button in the top navigation or click here....
-
Lift Compatibility (M301.4 and M302.4)
ANSI/AAMI HE 75 recommends that the “base of the device needs to have space underneath or along both sides (if the equipment is narrow) to accommodate the legs of portable mechanical lift...
-
If a property owner hits the 20% cost cap on path of travel improvements when installing charging stations, are there any other accessibility site retrofits that would still be required?
RESPONSE: EVCS required to be accessible by CBC Chapter 11B must have both, an accessible route to the facility entrance (see CBC Section 11B-812.5.1) and an accessible route from...
-
Assessment factors. (Section-by-Section Analysis)
concerns they did not offer the same level of support if the device were an off-highway vehicle, all-terrain vehicle (ATV), golf car, or other device with a fuel-powered or combustion engine...
-
Settlement Agreement Between the United States of America, Louisiana Tech University, and the Board of Supervisors for the University of Louisiana System Under the Americans with Disabilities Act
SETTLEMENT AGREEMENT BETWEEN THE UNITED STATES OF AMERICA, LOUISIANA TECH UNIVERSITY, AND THE BOARD OF SUPERVISORS FOR THE UNIVERSITY OF LOUISIANA SYSTEM UNDER THE AMERICANS WITH DISABILITIES...
-
III. Benefits of Ratification
Many of these products are engineered, made, or sold by U.S. corporations, who will benefit from an active U.S. presence to reach this emerging new source of revenue....
-
TECHNICAL QUESTIONS:
[See subsections ...]
-
11B-812.8.7 Location
Required identification signs shall be visible from the EVCS it serves. Signs shall be permanently posted either immediately adjacent to the vehicle space or within the projected...
-
11B-812.5.2 Accessible route to EV charger
An accessible route complying with Section 11B-402 shall connect the vehicle space and the EV charger which serves it.
-
11B-812.8.4 Ambulatory
Ambulatory EVCS shall not be required to be identified by an ISA.
-
11B-812.8.6 Finish and size
Identification signs shall be reflectorized with a minimum area of 70 square inches (45,161 mm2).
-
11B-812.5.2 Accessible route to EV charger
An accessible route complying with Section 11B-402 shall be provided between the vehicle space and the EV charger which serves it.
-
11B-812.8.7 Location
Required identification signs shall be visible from the EVCS it serves. Signs shall be permanently posted either immediately adjacent to the vehicle space or within the projected...
-
11B-812.8.4 Ambulatory
Ambulatory EVCS shall not be required to be identified by an ISA.
-
11B-812.8.6 Finish and size
Identification signs shall be reflectorized with a minimum area of 70 square inches (45161 mm2).
-
Assessment factors. (Section-by-Section Analysis)
concerns they did not offer the same level of support if the device were an off-highway vehicle, all-terrain vehicle (ATV), golf car, or other device with a fuel-powered or combustion engine...
-
If a state or local authority interprets an accessibility requirement differently than how a comparable requirement in the ADA Standards is interpreted under the ADA (or waives that requirement completely), does this have any bearing on ADA compliance?
may interpret or waive their own state or local accessibility codes as they see fit, those decisions have no effect on the obligation to comply with requirements of the applicable ADA Standards...
-
7. Commit to Ongoing Maintenance of Accessible Playground Surfaces as a Responsibility of Ownership
Each of the 16 participating municipalities had maintenance personnel trained through either the National Recreation and Park Association’s Certified Playground Safety Inspector program...
-
11B-706.2 Receiver jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
706.2 Receiver Jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
11B-706.2 Receiver jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
706.2 Receiver Jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack. [ECTCR UFAS 4.33.7]...
-
706.2 Receiver Jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....