Steps on non-rail vehicles shall comply with T405.
Search Results "OTRB: Over-the-Road Bus"
Commonly Searched Documents
-
T203.1 General
-
CHAPTER 2: SCOPING REQUIREMENTS
[See subsections ...]
-
12185(a) Purposes
(a) Purposes The Office of Technology Assessment shall undertake a study to determine
- QUANTUM
-
§ 38.159(b)(7) Platform gaps
(7) Platform gaps. Any openings between the platform surface and the raised barriers shall not exceed 5/8 inch (16 mm) in width. When the platform is at vehicle floor height with the...
-
§ 38.159(d)(2) Location and size
(2) Location and size. The securement system shall be placed as near to the accessible entrance as practicable and shall have a clear floor area of 30 inches (760 mm) by 48 inches...
-
§ 38.159(c)(3) Ramp threshold
(3) Ramp threshold. The transition from roadway or sidewalk and the transition from vehicle floor to the ramp may be vertical without edge treatment up to 1/4 inch (6.5 mm). Changes...
-
§ 38.159(c)(6) Attachment
(6) Attachment. When in use for boarding or alighting, the ramp shall be firmly attached to the vehicle so that it is not subject to displacement when loading or unloading a heavy...
-
§ 37.7 Standards for accessible vehicles
[56 FR 45621, Sept. 6, 1991, as amended at 58 FR 63101, Nov. 30, 1993; 61 FR 25416, May 21, 1996]
-
8. Add § 37.169 to read as follows
8. Add § 37.169 to read as follows:
-
§ 38.159(b)(5) Platform barriers
ramp when the lift is at ground level, shall be sufficient when raised or closed, or a supplementary system shall be provided, to prevent a power wheelchair or mobility aid from riding over...
- Q'Straint : QUANTUM - Complete Wheelchair Securement in 25 Seconds
- Q'Straint : QUANTUM User Experience - A First Hand Account
- Q'Straint : QUANTUM Automatic Rear-Facing Wheelchair Securement Station
- Q'Straint : On Board with the QUANTUM - Automatic Wheelchair Securement
- Q'Straint : Importance and Benefits of QUANTUM Automatic Wheelchair Securement
-
T201 General
Buses, OTRBs, and vans acquired or remanufactured by entities covered by the ADA must comply with the scoping requirements in Chapter 2 to the extent required by DOT’s implementing regulations...
-
(1)(e)
(e) Doorways on the end of the enclosure, opposite the water closet, should have a minimum clear opening width of 32 inches (815 mm). Door latches and hardware should be operable...
-
§ 38.153(c)(2) Exception
(2) Exception. Where compliance with the door width requirement of paragraph (c)(1) of this section is not feasible, the minimum door width shall be 27 in (685 mm).
-
§ 37.209 Training and other requirements
OTRB operators shall comply with the requirements of §§37.161, 37.165-37.167, and 37.173....
-
T502.2 Doorways with Lifts, Ramps or Bridgeplates
The vertical clearance at doorways with lifts, ramps or bridgeplates shall comply with T502.2. Vertical clearance shall be measured from the inside finished edge of the door opening...
-
§ 38.159(c)(5) Slope
(5) Slope. Ramps shall have the least slope practicable and shall not exceed 1:4 when deployed to ground level. If the height of the vehicle floor from which the ramp is deployed is...
-
§ 38.159(b)(8) Platform entrance ramp
(8) Platform entrance ramp. The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, measured on level ground, for a maximum rise of 3 inches (75...
-
§ 38.159(d)(7) Seat belt and shoulder harness
(7) Seat belt and shoulder harness. For each wheelchair or mobility aid securement device provided, a passenger seat belt and shoulder harness, complying with all applicable...