I use the term artificial lighting, but electric lighting is a very powerful tool and component in our built environment....
Search Results "Light Rail"
Filters
Commonly Searched Documents
-
Mary Ann Hay, IALD, LEED™ AP. Artificial Lighting
-
810.5.3 Platform and Vehicle Floor Coordination
Note to Reader: The Department of Transportation’s ADA standards note permitted alternatives where compliance is not operationally or structurally feasible in light rail, commuter rail,...
-
Effects of Lighting and Daylighting on Performance
Lighting is one of the biggest problems. Over 20 percent say moderate effect and only 11 percent say it has no effect. So lighting is a very important consideration....
-
§ 38.79(a)
(a) Floor surfaces on aisles, step treads, places for standees, and areas where wheelchair and mobility aid users are to be accommodated shall be slip-resistant.
-
§ 38.77 Interior circulation, handrails and stanchions
[See subsections ...]
-
§ 38.83(c)(1) Design load
(1) Design load. Ramps or bridge plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26...
-
§ 38.83(c)(7) Stowage
(7) Stowage. A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps or bridge plates, including portable ramps or bridges plates...
-
§ 38.83(c)(6) Attachment
(6) Attachment—
-
§ 38.83(c) Vehicle ramp or bridge plate
(c) Vehicle ramp or bridge plate—
-
§ 38.83(b)(2) Controls
(2) Controls—
-
§ 38.83(b)(12) Use by standees
(12) Use by standees. Lifts shall accommodate persons using walkers, crutches, canes or braces or who otherwise have difficulty using steps. The lift may be marked to indicate a...
-
§ 38.83(b)(3) Emergency operation
(3) Emergency operation. The lift shall incorporate an emergency method of deploying, lowering to ground level with a lift occupant, and raising and stowing the empty lift if the...
-
§ 38.83(b)(1) Design Load
(1) Design load. The design load of the lift shall be at least 600 pounds. Working parts, such as cables, pulleys, and shafts, which can be expected to wear, and upon which the lift...
-
12147(b) Special rule for stations
(b) Special rule for stations
-
11B-810.5 Rail Platforms
Rail platforms shall comply with Section 11B-810.5....
-
Section 37.121 Requirement for Comparable Complementary Paratransit Service
This requirement applies to light and rapid rail systems as well as to bus systems, even when rail and bus systems share all or part of the same service area....
-
Eunice Noell-Waggoner, IES, LC. Lighting Issues
for our lighting....
-
11B-407.4.10 Support rail
Support rails shall be provided on at least one wall of the car. Advisory 11B-407.4.10 Support rail....
-
§ 38.73(d) Coordination with boarding platform
(d) Coordination with boarding platform—
-
§ 38.75(b)
(b) Where designated wheelchair or mobility aid seating locations are provided, signs shall indicate the location and advise other passengers of the need to permit wheelchair and...
-
§ 38.75 Priority seating signs
[See subsections ...]
-
AJW Architectural Products UG120-Railing UG120X-Y108 108" Exposed Flange, 1.25" Diameter, Peened Grip - Configuration Y
Product Features 1 1/4" bar diameter. Exposed Flange. Custom sizes available upon request. Peened saftey grip. Product Specs Tubing: Fabricated of #18 ga stainless...
-
AJW Architectural Products UG2-Railing UG2X-Y108 108" Concealed Snap Flange, 1.25" Diameter, Peened Grip - Configuration Y
Product Features 1 1/4" bar diameter. Snap flange. Custom sizes available upon request. Peened safety grip. Product Specs Tubing: Fabricated of #18 ga stainless...
-
AJW Architectural Products UG3-Railing UG3X-Y108 108" Concealed Snap Flange, 1.5" Diameter, Peened Grip - Configuration Y
Product Features 1 1/2" bar diameter. Snap flange. Custom sizes available upon request. Peened safety grip. Product Specs Tubing: Fabricated of #18 ga stainless...
