EXCEPTION: Where seats are provided, TTYs shall not be required to comply with 704.4.1. Advisory 704.4.1 Height....
Search Results "State Requirement"
-
704.4.1 Height
-
221.2.3.1 Horizontal Dispersion
Horizontal dispersion shall not be required in assembly areas with 300 or fewer seats if the companion seats required by 221.3 and wheelchair spaces are located within the 2nd or 3rd quartile...
-
216.2 Designations
EXCEPTION: Exterior signs that are not located at the door to the space they serve shall not be required to comply with 703.2. Advisory 216.2 Designations....
-
809.4 Toilet Facilities and Bathing Facilities
No fewer than one of each type of fixture provided shall comply with applicable requirements of 603 through 610....
- Susan Moe
-
407.12 Reach Height (Section-by-Section Analysis)
407.12 Reach Height (Section-by-Section Analysis) This section proposes requirements for the height of side and forward reaches that would enable persons using wheelchairs or other mobility...
-
410.6 Real-Time Text Functionality (Section-by-Section Analysis)
Proposed 410.6 would require that, where ICT supports real-time voice communication, it must also support RTT functionality....
-
M304 Diagnostic Equipment Used by Patients in Standing Position
The proposed standards do not require diagnostic equipment to support more than one position....
-
Communication. (Section-by-Section Analysis)
Several large disability advocacy organizations commented on the 2004 ADAAG section 232.2.2 requirement that at least 2 percent of the general holding cells and housing cells must be equipped...
-
11B-604.3.2 Overlap
routes, clear floor space and clearances required at other fixtures, and the turning space....
-
11B-604.3.2 Overlap
routes, clear floor space and clearances required at other fixtures, and the turning space....
-
11B-224.7.2 Multi-bedroom housing units with adaptable features
Multi-bedroom housing units with adaptable features shall be provided as required by Section 11B-233.3.1.2....
-
Providing Comforts and Conveniences—Constructed Features
The requirements for constructed features are addressed in sections 3, 4, and 5 of FSORAG....
-
HOUSING AT A PLACE OF EDUCATION
The requirements in CBC Chapter 11A for privately owned covered multifamily dwellings shall be applied in lieu of 11B-224.7.2 for accessible dwelling units with adaptable features. ◼...
-
11B-802.1.2 Width
Figure 11B-802.1.2 (b) depicts paired wheelchair spaces requiring a total of 66 inches in width....
-
11B-812 Electric vehicle charging stations
However, the absence of scoping or technical requirements in the Standards would make it difficult to conclude what that means....
-
11B-404.3.5 Controls
Doors should not swing into the required clear floor or ground space for the operating device. ◼...
-
Sales and Service Counters: ADA Standard Section 904.4
or a reduction of the number of existing mail boxes, the counter shall be permitted to have a portion which is 24 inches (610 mm) long minimum complying with 904.4.1 provided that the required...
-
General: ADA Standard Section 803.1
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
General: ADA Standard Section 217.1
Section 217.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for telephones.
-
Golf Facilities: ADA Standard Section 206.2.15
Section 206.2.15 covers scoping requirements in the most current ADA Standards for accessible routes to golf facilities
-
11B-802.1.2 Width
Figure 11B-802.1.2 (b) depicts paired wheelchair spaces requiring a total of 66 inches in width....
-
11B-404.3.5 Controls
Doors should not swing into the required clear floor or ground space for the operating device. ◼...
-
Components: ADA Standard Section 402.2
Section 402.2 covers the current ADA Standards for components of an accessible routes.
