Minimum maneuvering clearances at doors and gates shall comply with Section 11B-404.2.4....
Search Results "Circular Cross Section"
Filters
Commonly Searched Documents
-
11B-404.2.4 Maneuvering clearances
-
68.101. State Leases
(Effective April 1, 1994, 19 TexReg 167; amended effective June 26, 2000, 25 TexReg 6122; repealed effective November 5, 2001, 26 TexReg 8807, new rule section effective November 5, 2001...
-
Armrests (M302.3.2)
See ANSI/AAMI HE 75, section 16.4.7 (e)....
-
1132A.8 Hand-activated door hardware
Locked exit doors shall operate consistent with Section 1132A.6, in the direction of egress....
-
§ 37.41(a)
For purposes of this section, a facility or station is “new” if its construction begins (i.e., issuance of notice to proceed) after January 25, 1992, or, in the case of intercity or commuter...
-
List of Subjects for 28 CFR Part 35
• By the authority vested in me as Attorney General by law, including 28 U.S.C. 509 and 510, 5 U.S.C. 301, and section 204 of the Americans with Disabilities Act of 1990, Pub....
-
WHEELCHAIR
This definition does not apply to Federal wilderness areas; wheelchairs in such areas are defined in section 508(c)(2) of the ADA, 42 U.S.C. 12207(c)(2)....
-
1.9.1.8 Adopting agency identification
ETA Editor's Note Sections from the California Building Code Chapter 1 that are not adopted by Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
11B-206.4.8 Service entrances
If a service entrance is the only entrance to a building or to a tenancy in a facility, that entrance shall comply with Section 11B-404....
-
11B-1009.3 Sloped entries
Sloped entries shall comply with Section 11B-1009.3. [2010 ADAS] Advisory 1009.3 Sloped Entries....
-
11B-217.4.1 Bank requirement
Where four or more public pay telephones are provided at a bank of telephones, at least one public TTY complying with Section 11B-704.4 shall be provided at that bank....
-
§ 37.135(c)(1)
ETA Editor's Note The above referenced section 37.138 does not currently exist, according to ecfr.gov....
-
11B-607.4.2.1 Back wall
Two grab bars shall be installed on the back wall, one located in accordance with Section 11B-609.4 and the other located 8 inches (203 mm) minimum and 10 inches (254 mm) maximum above the...
-
11B-216.8.1 Geometric symbols
Geometric symbols complying with Section 11B-703.7.2.6 shall be provided at entrances to toilet and bathing rooms. Exceptions: 1. ...
-
11B-407.4.6.1 Location
Controls shall be located within one of the reach ranges specified in Section 11B-308. Exceptions: 1....
-
11B-407.4.7.2 Keypads
Keypads shall be identified by characters complying with Section 11B-703.5 _|Signs; Visual Characters|_ and shall be centered on the corresponding keypad button....
-
11B-209.5 Mechanical access parking garages
Mechanical access parking garages shall provide at least one passenger drop-off and loading zone complying with Section 11B-503 at vehicle drop-off and vehicle pick-up areas....
-
907.5.2.3.3 Group R-2
In Group R-2 occupancies required by Section 907 to have a fire alarm system, all dwelling units and sleeping units shall be provided with the capability to support visible alarm notification...
-
§ 38.179(a)
providing shuttle service to remote parking areas, between hotels and other public accommodations, and between and within amusement parks and other recreation areas, shall comply with this section...
-
11B-304.3.2 T-Shaped space
The space shall be permitted to include knee and toe clearance complying with Section 11B-306 only at the end of either the base or one arm. ...
-
11B-813.2.1.2 Clearance
Floor or ground surfaces of clearances shall comply with Section 11B-302. Changes in level are not permitted....
-
1132A.8 Hand-activated door hardware
Locked exit doors shall operate consistent with Section 1132A.6, in the direction of egress....
-
11B-404.2.4 Maneuvering clearances
Minimum maneuvering clearances at doors and gates shall comply with Section 11B-404.2.4....
-
11B-604.9.6 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...