As a result of the information provided, the Department considered a variety of alternatives in the final rule. ...
Search Results "Alternative Accessibility Standard"
Commonly Searched Documents
-
7.6. Measures Taken to Limit Impact on Small Entities
-
402.2 Speech-Output Enabled (Section-by-Section Analysis)
that operating instructions and orientation, visible transaction prompts, user input verification, error messages, and all displayed information necessary for full use, would have to be accessible...
-
Additional Training Modules (Call ETA for details)
Proposed New ADA Sections for Public Entities (Interim Final Guidelines) (80 - 120 minutes) Proposed Changes to ADAAG Requirements (10 - 90 minutes) Comparing a State or Local Standard...
-
17. Tests and selection criteria
a) prohibits employers from using test or other selection criteria that screen out or tend to screen out handicapped persons unless the test or criterion is shown to be job-related and alternative...
-
11B-606.2 Clear floor space
[2010 ADA Standards] 2....
-
§ 36.406(c) Places of lodging.
Places of lodging subject to this part shall comply with the provisions of the 2010 Standards applicable to transient lodging, including, but not limited to, the requirements for transient...
-
§35.103(a)
Except as otherwise provided in this part, this part shall not be construed to apply a lesser standard than the standards applied under title V of the Rehabilitation Act of 1973 or the regulations...
-
§ 35.103(a) Rule of interpretation
Except as otherwise provided in this part, this part shall not be construed to apply a lesser standard than the standards applied under title V of the Rehabilitation Act of 1973 or the regulations...
- BEST Door Lever Hardware Cylindrical Locks - 5K
-
PART 1: OVERVIEW AND GENERAL REQUIREMENTS
These statutes require medical care providers to make their services available in an accessible manner....
- Whitehall Mfg. Ligature Resistant Bariatric Stainless Steel Basin
- SciFit PRO1 - Upper Body Machine
- United Cerebral Palsy (UCP)
-
Executive Order 13563 (Improving Regulation and Regulatory Review) and Executive Order 12866 (Regulatory Planning and Review)
determination that its benefits justify its costs; tailor the regulation to impose the least burden on society, consistent with obtaining the regulatory objectives; and, in choosing among alternative...
-
Final Regulatory Flexibility Analysis
The Regulatory Flexibility Act requires federal agencies to consider the impacts of their rules on small entities, analyze alternatives that minimize the impacts on small entities, and to...
-
Water closet
Alternatively, for individuals capable of independent transfer, grab bars on both sides would enable them to pull up to a standing position and lower down to a sitting position (Sanford...
-
C102.4 Advanced Television Systems Committee (ATSC)
Copies of the referenced standard may be obtained from the Advanced Television Systems Committee, 1776 K Street NW, Suite 200, Washington, DC 20006-2304 (http://www.atsc.org)....
-
E102.4 Advanced Television Systems Committee (ATSC)
Copies of the referenced standard may be obtained from the Advanced Television Systems Committee, 1776 K Street NW, Suite 200, Washington, DC 20006-2304 (http://www.atsc.org/)....
-
Employee Parking Lot
Are employee parking lots considered parking facilities under the 2010 Standards requiring accessible spaces? ...
-
6.2. Scoping Requirements
Table 6-4 : Original Scoping Alternative, Discounted at 7 Percent ($ millions) Cost Category Initial RA Scoping Alternative Primary Analysis...
-
11B-233.1 General
For ADA scoping requirements of Title II §35.151(e) New Construction and Alterations; Social Service Center Establishments, Title III §36.406(d) Standards for New Construction and Alterations...
-
11B-403.3 Slope
When the running slope of a walking surface exceeds 5%, it must comply with the accessibility requirements for ramps....
-
11B-403.3 Slope
When the running slope of a walking surface exceeds 5%, it must comply with the accessibility requirements for ramps....
-
104 Conventions
Section 104.1 of the 2010 Standards notes that dimensions not stated as a “maximum” or “minimum” are absolute....