[2010 ADA Standards] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
Search Results "TAS: Texas Accessibility Standards"
-
11B-407.2.1.1 Height
-
11B-407.2.1.1 Height
[2010 ADA Standards] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
-
11B-407.2.2.1 Visible and audible signals
[2010 ADA Standards] 2. In existing elevators, a signal indicating the direction of car travel shall not be required....
-
11B-407.4.6.2.1 Size and shape
[2010 ADA Standards] 407.4.6.2.1 Size. Buttons shall be ¾ inch (19 mm) minimum in their smallest dimension....
-
11B-202.5 Alterations to qualified historic buildings and facilities
Alternative provisions and equivalent facilitation are applied on a case-by-case basis only. ◼ [2010 ADA Standards] 202.5 Alterations to Qualified Historic Buildings and Facilities...
-
702.3 Association for Information and Image Management (AIIM)
Copies of the referenced standard may be obtained from AIIM,1100 Wayne Ave., Ste. 1100, Silver Spring, Maryland 20910 (http://www.aiim.org/Resources/Standards/AIIM_ISO_14289-1)....
-
§1193.51(b) Connection point for external audio processing devices
Products providing auditory output shall provide the auditory signal at a standard signal level through an industry standard connector....
-
B. Advisory Committee and Final Report (2006-2008)
In the years following our initial promulgation of the 508 Standards and 255 Guidelines, technology continued to evolve at a rapid pace....
-
M301.4.1 Clearance in Base (Section-by-Section Analysis)
Additionally, the Access Board proposed to permit equipment components to be located within 8 inches maximum of the centerline of the clearance width. Id....
-
3.3.9 Toe Clearance Depth, minimum
3.3.9 Toe Clearance Depth, minimum Toe clearance depths for the standards range from 150 mm (6 in.) in the U.S. to 230 mm (9 in.) in Canada (Figure 3‒9)....
- Yale 8800 Series Grade 1 Mortise Locks
-
Services and Facilities
In addition, all buildings, including those built before the ADA went into effect, are subject to accessibility requirements for existing facilities....
-
3.3.1 Research Data
Access Board staff to find as many studies as possible that were relevant to various accessibility standards....
-
III-4.4600 Seating in assembly areas
Public accommodations are required to remove barriers to physical access in assembly areas such as theaters, lecture halls, and conference rooms with fixed seating....
-
Knee and Toe Clearance (M303.2.4)
The Access Board is considering requiring in the final standards the dimensions for toe clearance and knee clearance recommended by the Wheeled Mobility Anthropometry Project....
-
Does the Americans with Disabilities Act (ADA) apply to the Forest Service?
However, if an agency decides to construct a facility, it must be accessible....
-
3.1 Refining MDE Definition and Committee Scope
standards....
-
11B-405.5 Clear width
[2010 ADA Standards] 405.5 Clear Width. The clear width of a ramp run and, where handrails are provided, the clear width between handrails shall be 36 inches (915 mm) minimum....
-
11B-405.2 Slope
[2010 ADA Standards] EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such...
-
11B-405.5 Clear width
[2010 ADA Standards] 405.5 Clear Width. The clear width of a ramp run and, where handrails are provided, the clear width between handrails shall be 36 inches (915 mm) minimum....
-
11B-405.2 Slope
[2010 ADA Standards] EXCEPTION: In existing sites, buildings, and facilities, ramps shall be permitted to have running slopes steeper than 1:12 complying with Table 405.2 where such...
-
Triggering event
Site preparation includes providing an accessible route to the element....
-
Triggering event. (Section-by-Section Analysis)
Site preparation includes providing an accessible route to the element....
-
§40.6 Records.
agency's file on each contract, grant, or loan involving the design, construction, or alteration of a residential structure shall include appropriate documentation indicating: (a) That the standards...