Exception: Labeling is not required where the top of the protection plate is not more than 16 in. (406 mm) above the bottom of the door....
Search Results "Supplemental Requirement"
Commonly Searched Documents
- Rockwood Manufacturing Company K1038 .038" Thick - Metal Kick Plate
- BEST B.A.S.I.S.® V Door Lever Hardware with Card Reader
- Pilot Rock APTX Full Sized Pedestal Rectangular Utility Table Using Lumber
- Whitehall Mfg. Hot & Cold Piezo Pushbuttons Electronic Valve Conical Faucet 8" Centerset
- Whitehall Mfg. Single Temp Piezo Pushbutton Electronic Valve Conical Faucet 8” Centerset
- Pilot Rock APTX Full Sized Pedestal Rectangular Utility Tables Using Recycled Plastic
- Pilot Rock T700 Square Frame Rectangular Utility Table
- NetCentric Technologies Inc. CommonLook PDF GlobalAccess Software
- Hamilton CapTel Apps for PC/Mac
- Inclusion Solutions FuelCall™ Gas Station Refueling Assistance
- KirbyBuilt Providence Picnic Table with Maximum Seating
- Symmons Hand Shower T-600B-36-V
-
[F] 907.4.2.2 Height
Exception: [DSA-AC] In existing buildings there is no requirement to retroactively relocate existing manual fire alarm boxes to a minimum of 42 inches (1067 mm) and a maximum of 48 inches...
-
11B-1002.2 Accessible routes
In load or unload areas and on amusement rides, handrails provided along walking surfaces complying with Section 11B-403 and required on ramps complying with Section 11B-405 shall not be...
-
Sharing an Access Aisle
Requirements for access aisles in section 502.3 address width, length, marking, and location. Two spaces are permitted to share an access aisle....
-
104 Conventions
In the final rule, the Board has limited this provision so that it does not apply to requirements where a range is provided since the specified range offers adequate tolerances....
-
TEST NO. 3 – UNUSUAL CHARACTERISTICS TEST
UNUSUAL CHARACTERISTICS TEST Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements...
-
Is it prohibited to draw majority-minority districts?
Later Supreme Court decisions have held that drawing majority-minority districts may be required to ensure compliance with the Voting Rights Act....
-
404.2.3 Clear Width
There shall be no projections into the required clear opening width lower than 34 inches (865 mm) above the finish floor or ground....
-
IV. Request for Public Comments
those who have a stake in ensuring that the websites of public accommodations and public entities are accessible to people with disabilities or would otherwise be affected by regulations requiring...
-
G.6.iv. - What should be included in the undue burden determination?
The FAR requires the requiring activity official to document in writing the basis for an undue burden decision and provide a copy to the contracting officer for inclusion in the contracting...
-
Technical Memorandum TM 2013-16 Residential Amenity Centers
*For purposes of amenity center requirements, the term "residents" referenced in Rule 68.30(5) shall mean persons that are members of the homeowners association (HOA) or residents of the...
-
Sell-outs of specific price ranges. (Section-by-Section Analysis)
Question 22: Although not included in the proposed regulation as currently drafted, the Department is soliciting comment on whether additional regulatory guidance is required or appropriate...
-
Maneuvering Space at Doors
The Department believes that, by adhering to the standard 32-inch clear opening, it is possible to forego other accessibility requirements related to doors (e.g. door closing forces, maneuvering...