Height preferences for toilet seats vary considerably among disabled people. Higher seat heights may be an advantage to some ambulatory disabled people, but are often a disadvantage...
Search Results "Water Spray Unit"
-
A4.16.3 Height
-
A4.16.3 HEIGHT
Preferences for toilet seat heights vary considerably among disabled people. Higher seat heights may be an advantage to some ambulatory disabled people but a disadvantage for...
-
5.3.3.1 Height
The total height of the toilet seat on the riser for a pit toilet shall be between 17 inches (430 mm) and 19 inches (485 mm) above the floor or ground surface.
-
Length
Length. Whereas none of the respondents specifically addressed the issue of grab bar length, drawings submitted clearly indicate that many of the alternate swing away grab bars were...
-
§8.32(d)
(d) For purposes of this section, section 4.1.4(11) of UFAS may not be used to waive or lower the minimum of five percent accessible units required by §8.22(b) or to apply the minimum only...
-
Position of Grab Bars: ADA Standard Section 609.4
Section 609.4 covers the current ADA Standards for the position of grab bars.
-
11B-233.3.1.1 Residential dwelling units with mobility features
In facilities with residential dwelling units, at least 5 percent, but no fewer than one unit, of the total number of residential dwelling units shall provide mobility features complying...
-
907.5.2.3.2 Groups R-1 and R-2.1
Habitable spaces in dwelling units and sleeping units in Group R-1 and R-2.1 occupancies in accordance with Table 907.5.2.3.2 shall be provided with visible alarm notification....
-
Pool Lifts
Pool Lifts Pool lifts must be located where the water level is not deeper than 48 inches....
-
28.1 Q. If an architect or builder chooses to follow the bathroom specifications in Requirement 7...are the other bathrooms in the dwelling unit required to have reinforced walls for grab bars?
A. Yes. Requirement 6 of the Guidelines requires reinforced walls in bathrooms for later installation of grab bars. Even though Requirement 6 was not repeated under Requirement...
-
11B-609.4 Position of grab bars
shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface, except that at water...
-
11B-609.4 Position of grab bars
shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface, except that at water...
-
604.5.1 Side Wall
Figure 604.5.1 Side Wall Grab Bar at Water Closets...
-
11B-602.3 Operable parts
The flow of water shall be activated by a manually operated system that is front mounted or side mounted and located within 6 inches (152 mm) of the front edge of the fountain or an automatic...
-
Definition [F106.5]
A camping facility is a site, or a portion of a site, that is developed for outdoor recreational purposes and contains camping units....
-
11B-216.5.1 Parking spaces
In residential facilities, where parking spaces are assigned to specific residential dwelling units, identification of accessible parking spaces shall not be required....
-
11B-216.5.1 Parking spaces
In residential facilities, where parking spaces are assigned to specific residential dwelling units, identification of accessible parking spaces shall not be required....
-
Whitehall Mfg. WH2142W2 Ligature-Resistant Toilet Wall Supply On-Floor Wall Waste
Features: Siphon Jet type toilet with elongated bowl, configured for front mounted, on-floor installation. The toilet is fabricated with 16 gage 304 stainless steel with exterior...
-
Whitehall Mfg. Ligature Resistant Toilet Top Supply On-Floor
Model Number: WH2142-T-3 Series Features: Siphon Jet type toilet with elongated bowl, configured for front mounted, on-floor installation. The toilet is fabricated with 16...
-
Whitehall Mfg. WH2142T2 Ligature Resistant Toilet Top Supply On-Floor Wall Waste
Features: Siphon Jet type toilet with elongated bowl, configured for front mounted, on-floor installation. The toilet is fabricated with 16 gage 304 stainless steel with exterior...
-
604.5.1 Side Wall
[ECTCR UFAS 4.17.6, Fig. 30(a), Fig. 30(d)] Figure 604.5.1 Side Wall Grab Bar at Water Closets...
-
Residential Facilities: ADA Standard Section 215.5
Section 215.5 covers scoping requirements in the current ADA Standards for fire alarm systems in residential facilities.
-
F233.4.2 Residential Dwelling Units for Sale
Residential dwelling units offered for sale shall provide accessible features to the extent required by regulations issued by Federal agencies under Section 504 of the Rehabilitation Act...
-
4.34.2(7)
(7) At least one accessible entrance to the dwelling unit shall comply with 4.14....
