(B) establish minimum standards that shall be met in carrying out subsection (c) of this section;...
Search Results "TAS: Texas Accessibility Standards"
Filters
Commonly Searched Documents
-
225(d)(1)(B)
-
Station platforms
(DOT ADA Standard 810.5.3.)...
-
M18
[ADA Standards § 4.16.5] Yes No...
-
11B-705.1.1.3.1
Detectable warning surfaces shall be yellow and approximate FS 33538 of Federal Standard 595C....
-
§40.3(b)(3)
(3) The alteration of an existing building, or of such portions thereof, to which application of the standards is not structurally feasible....
-
ADMINISTRATIVE AUTHORITY
A governmental agency that adopts or enforces regulations and standards for the design, construction, or alteration of buildings and facilities....
-
§100.201a(b)
(b) The addresses of organizations from which the referenced standards can be obtained appear below:...
-
b. Telephone Communications
Telephone relay services involve a relay operator who uses both a standard telephone and a TTY to type the voice messages to the TTY user and read the TTY messages to the standard telephone...
-
List of Subjects
Revise part 1194 to read as follows: PART 1194 – INFORMATION AND COMMUNICATION TECHNOLOGY (ICT) STANDARDS AND GUIDELINES Sec. 1194.1 Standards for Section 508 of the Rehabilitation...
-
3.3.5 Seat Height
3.3.5 Seat Height Height dimension standards for seats prescribed in the Australian, Canadian and U.S. standards were very similar (480 mm or 18.9 in., 480 mm or 18.9 in. and 485 mm...
-
II-4.2000 Relationship among title II and other Federal laws that prohibit employment discrimination by public entities on the basis of disability
What standards are used to determine compliance under title II? For those public entities that are subject to title I of the ADA, title II adopts the standards of title I....
-
Yale YSSL10 Auxiliary Latch
Features ADA compliant thumbturn for ease of accessibility Backset: 2-3/4" Latchbolt: 1/2" brass throw For use with door thicknesses of 1-3/4" Non-handed, field reversible Strike...
-
ELKAY Filtered EZH2O® Mechanical Surface Mount with Battery-powered visual monitor LMASMB
Non-Electric Surface mount design - ideal for installations where electrical wiring is not easily accessible or locations looking to reduce electrical usage Push-button activation delivers...
-
Bobrick Swing-Up Grab Bar B-4998.99
Grab bar shall comply with ICC/ANSI A117.1-2003 Accessibility Standards in U. S. A.....
-
Mockett PCS49B Rectangular Power Grommet
No hideaways or pop-ups to figure out; this unit is exposed at all times for easy access. Rounded edges and a sleek finish for a universally subtle, yet sophisticated look....
-
E202.5 Undue Burden or Fundamental Alteration (Section-by-Section Analysis)
Undue Burden or Fundamental Alteration (Section-by-Section Analysis) This section proposes to retain the provisions in existing 508 Standards §§ 1194.3(e) and 1194.2(a)(1), but would...
-
11B-812 Electric vehicle charging stations
ETA Editor's Note EVCS are not addressed by 2010 ADA Standards, although a case could be made, based on the general obligation for governments to make their services, programs...
-
Signing Ceremony for Americans with Disabilities Act (July 26, 1990)
Requires the Registered User plan or above. Login! -
Poured in Place Rubber
Within the first 12 months of installation, the sites surfaced with PIP did not have any recorded locations where the surface samples exceeded the accessibility standards for slope, cross...
-
Relationship to Other Laws
Except as otherwise provided in this part, this part shall not be construed to apply a lesser standard than the standards applied under title V of the Rehabilitation Act of 1973, 29 U.S.C...
-
The Commenters
The commenters included several national, State and local organizations and agencies, private firms, and individuals that have been involved in the development of State and local accessibility...
-
M201.1 Application by Enforcing Authority
The enforcing authority shall specify the number and type of diagnostic equipment that are required to comply with the MDE Standards....
-
407.2.1.6 Keypads
Where keypads are provided, keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
-
12101(b)(2)
(2) to provide clear, strong, consistent, enforceable standards addressing discrimination against individuals with disabilities;...
