3.1 Canton Tinseltown 15 4720 Mega Street NW North Canton, Ohio - In Auditorium 1, two additional wheelchair spaces and two additional companion seats shall be provided in the rear of...
Search Results "9-1-1 Service"
-
3.1 Canton Tinseltown 15, 4720 Mega Street NW North Canton, Ohio
-
11B-404.2.3 Clear width
Exceptions: 1. In alterations, a projection of 5/8 inch (15.9 mm) maximum into the required clear width shall be permitted for the latch side stop. 2. ...
-
11B-405.8 Handrails
Exceptions: 1. Reserved. 2. Reserved. 3. Curb ramps do not require handrails. 4. ...
-
Shower Threshold
The proposed rule specified a maximum threshold height of ½ inch, provided that those greater than ¼ inch are beveled with a slope of 1:2 maximum (608.7)....
-
308.3.2 Obstructed High Reach
[ECTCR UFAS 4.2.6, Fig. 6(c)] EXCEPTIONS: 1. The top of washing machines and clothes dryers shall be permitted to be 36 inches (915 mm) maximum above the finish floor. 2....
-
208.3.1 General
EXCEPTIONS: 1. All van parking spaces shall be permitted to be grouped on one level within a multi-story parking facility. 2....
-
Monitoring and Fees
Plaintiffs’ monitoring fees, costs and expenses, exclusive of any disputes resolved by the District Court, shall be paid out of the Annual Commitment and be capped as follows: Years 1-...
-
B. Summary of Major Provisions and Organization of Technical Criteria
The Access Board has divided the MDE Standards into separate technical criteria based on how the diagnostic equipment is used by the patient: (1) supine, prone, or side lying position (M301...
-
404.2.4.2 Doorways without Doors or Gates
inches (0 mm) From pocket/hinge side 42 inches (1065 mm) 22 inches (560 mm)2 From stop/latch side 42 inches (1065 mm) 24 inches (610 mm) 1....
-
404.2.3 Clear Width
EXCEPTIONS: 1. In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
604.5 Grab Bars
EXCEPTIONS: 1....
-
5.4.2 Transfer Support Length for M301 and M302
support shall be a minimum of 15 inches long and positioned so that the transfer support overlaps the length of the transfer surface by 80% at a maximum distance from the transfer surface of 1½...
-
"Existing Facility" (Section-by-Section Analysis)
Under the ADA, a facility is initially classified as one of three types: (1) An existing facility; (2) an altered facility; or (3) a newly designed and constructed facility. ...
-
Readily Achievable
In determining whether an action is readily achievable factors to be considered include – (1) The nature and cost of the action needed under this part; (2) The overall financial resources...
-
907.2.3 Group E
Exceptions: 1. Group E occupancies with an occupant load of less than 50. 2. Manual fire alarm boxes are not required in Group occupancies where all the following apply: 2.1....
-
Principles of Universal Design
. ________________________________________ 1 Center for Universal Design, North Carolina State University, Raleigh, NC, 1997....
-
711.4.2 Membrane penetrations
Where floor/ceiling assemblies are required to have a minimum 1-hour fire-resistance rating, recessed fixtures shall be installed such that the required fire resistance will not be reduced...
-
404.2.4.2 Doorways without Doors or Gates
Parallel to Doorway (beyond stop/latch side unless noted) From front 48 inches (1220 mm) 0 inches (0 mm) From side 1...
-
308.3.2 Obstructed High Reach
EXCEPTIONS: 1. The top of washing machines and clothes dryers shall be permitted to be 36 inches (915 mm) maximum above the finish floor. 2....
-
Sec.36.601 Definitions
Submitting official means the State or local official who -- (1) Has principal responsibility for administration of a code, or is authorized to submit a code on behalf of a jurisdiction...
-
Kitchen Counters, Walls, and Floors
Staggered stud construction to prevent noise transmission to other rooms Zero clearance kitchen entries with less than 1/4” change of elevation throughout the accessible route. ...
-
1017.3 Clear Tread Width
minimum clear tread width is to be maintained for the entire distance of the trail and may not be reduced by gates, barriers, or other obstacles unless an entity determines under Exception 1...
-
Compliance Requirements in Final Rule
The scoping requirements in the final rule are summarized in Table 1 under Executive Summary. Technical requirements specify the design criteria for accessible features....
-
Attachment B
well as any affiliated entities, successors, and assigns, without limitation, from any and all legal claims arising from or related to the facts and circumstances described in Paragraph 1...