(j) Products which are freestanding, non-portable, and intended to be used in one location and which have operable controls shall comply with the following:
Search Results "Vertical Actuation Bar"
-
§ 1194.25(j)
-
Sec.36.308(a)(1)(ii)(A)
(A) Are dispersed throughout the seating area;
-
4.11.3 Entrance
If platform lifts are used then they shall facilitate unassisted entry, operation, and exit from the lift in compliance with 4.11.2.
-
4.11.3 ENTRANCE
If platform lifts are used, then they should facilitate unassisted entry and exit from the lift in compliance with 4.11.2.
-
6.9
OR b. the measurement of the vertical viewing angle (the angle between a horizontal line from the eye to the screen and a line from the eye to the top of the screen) are within the range...
-
11B-608.3.2 Standard roll-in type shower compartments
Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the seat....
-
11B-608.3.2 Standard roll-in type shower compartments
Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the seat....
-
ASME A18.1 Safety Standard [§410.1]
The ASME A18.1 Standard recognizes two types of platform lifts: vertical platform lifts and inclined platform lifts....
- Figure 609.2.2 Grab Bar Non-Circular Cross Section – Drawing from the U.S. Access Board
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
608.3.2 Standard Roll-In Type Shower Compartments
Grab bars shall not be provided above the seat. Where a seat is not provided in standard roll-in type shower compartments, grab bars shall be provided on three walls....
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
4.1.6(1)(f)
(f) If an escalator or stair is planned or installed where none existed previously and major structural modifications are necessary for such installation, then a means of accessible vertical...
-
T502.2 Doorways with Lifts, Ramps or Bridgeplates
The vertical clearance at doorways with lifts, ramps or bridgeplates shall comply with T502.2....
-
4.26.3(2)
(2) Shear stress induced in a grab bar or seat by the application of 250 lbf (1112N) shall be less than the allowable shear stress for the material of the grab bar or seat....
-
Dune Crossings [1018.10]
The technical requirements for dune crossings do not address the vertical pickets provided in some handrail designs....
-
Dispensers [4.16.6]
Dispensers [4.16.6] Toilet paper dispensers should be located below the side grab bar so that they do not obstruct use of this bar....
- Federal Elevator Carelift Wheelchair Lift
- Harmar TG400 Toe Guard Commercial Platform Lift
- Harmar CPL800H-1400H Hydraulic CPL with Modular Tower
-
4.26.3(1)
(1) Bending stress in a grab bar or seat induced by the maximum bending moment from the application of 250 lbf (1112N) shall be less than the allowable stress for the material of the grab...
-
Technical Memorandum TM 2013-19 Private Toilet and Bathing Rooms
Water Closets 604.4, Exception 1: Seats 604.5, Exception 1: Grab Bars. Lavatories and Sinks 606.2, Exception 2: Clear Floor Space 606.3, Exception 1: Height....
-
28.1 Q. If an architect or builder chooses to follow the bathroom specifications in Requirement 7...are the other bathrooms in the dwelling unit required to have reinforced walls for grab bars?
Requirement 6 of the Guidelines requires reinforced walls in bathrooms for later installation of grab bars....
-
4.1.6(1)(b)
(b) If power-driven vertical access equipment (e.g., escalator) is planned or installed where none existed previously, or if new stairs (other than stairs installed to meet emergency exit...