Loose particles are also known for lodging in the TIL seams causing separation at the seams....
Search Results "Separation"
Filters
Commonly Searched Documents
-
6. Recognize that Proper Installation of Play Surface Systems is Key
-
Battery-powered Wheelchairs
or (ii) the battery-powered wheelchair with a spillable battery can be loaded, stored, secured, and unloaded in an upright position, you must not require the battery to be removed and separately...
-
Section 504 of the Rehabilitation Act (Section 504)
In the remainder of this document, Section 504 is not separately discussed....
-
4. Proposed Updates to Other Web-Specific Provisions in Existing 508 Standards
Are there any concerns that unrestricted use of conforming alternate versions of Web pages may lead to the unnecessary development of separate Web sites or unequal services for individuals...
-
8.2.2 Stimuli
Stimuli for the reverberation plus noise condition were recorded in three separate environments: a classroom, an auditorium, and a conference room....
-
Tiles
Some of the particles had started to lodge in the TIL seams causing separation at the seams. ...
-
Poured in Place Rubber
These two sites were assessed with locations throughout the playground where the large particles had separated from the bonded layer in chunks. ...
-
6.4 Post-Offer Examinations and Inquiries Permitted
The ADA requires only that such examinations be conducted as a separate, second step of the selection process, after an individual has met all other job pre-requisites....
-
II. Overview of Requirements
Public accommodations must -- Provide goods and services in an integrated setting, unless separate or different measures are necessary to ensure equal opportunity. ...
-
Issue 2: Location relative to the crosswalk
Where the sidewalk is separated from the curb, use a returned curb rather than a flare at the ramp (good for wayfinding, if properly aligned) and locate the stub pole within the border adjacent...
-
Issue 11: Good vibrations (vibrotactile indications)
Vibrotactile indications may have separate wires to attach in order to enable the feature....
-
Truncated Domes
The center-to-center spacing of domes has been changed from 2.35 inches absolute, to a range of 1.6 inches minimum to 2.4 inches maximum, with a minimum separation measured at the base of...
-
Accessible Boat Slips
There are three exceptions: The width of the clear pier space may be 36 inches wide for a length of 24 inches, as long as multiple 36-inch segments are separated by segments...
-
R208 Detectable Warning Surfaces (Section-by-Section Analysis)
than 1.8 meters (6 feet) in length in the direction of pedestrian travel because detectable warning surfaces must extend 610 millimeters (2 feet) minimum on each side of the island and be separated...
-
1003.3.1 Boat Slip Clearance
Clear pier space shall be permitted to be 36 inches (915 mm) wide minimum for a length of 24 inches (610 mm) maximum, provided that multiple 36 inch (915 mm) wide segments are separated...
-
How can existing buildings be retrofitted to make them accessible?
At such facilities a separate ramp or an alternative entrance may have to be used. This may include adding an elevator or lift inside a two-story building....
-
Subpart F—Health, Welfare, and Social Services
Since the separate provisions that appeared in the proposed regulation were almost identical, no substantive change should be inferred from their consolidation....
-
68.31. Variance Procedures
A separate Variance Application form shall be submitted for each TAS standard within a single building or facility....
-
11B-1003.3.1 Boat slip clearance
Clear pier space shall be permitted to be 36 inches (914 mm) wide minimum for a length of 24 inches (610 mm) maximum, provided that multiple 36 inch (914 mm) wide segments are separated...
-
11B-1003.3.1 Boat slip clearance
Exceptions: Clear pier space shall be permitted to be 36 inches (914 mm) wide minimum for a length of 24 inches (610 mm) maximum, provided that multiple 36 inch (914 mm) wide segments are separated...
-
11B-208.3.1 General
The minimum number of spaces must still be determined separately for each facility even if the spaces are to be provided in other facilities or locations....
-
Bradley Surface Mounted Tank-Type Vertical Valve Soap Dispenser 6562
Secure separate mounting bracket to wall. Slide dispenser into place and secure locking screw through filler hole....
-
Norton Surface Mounted Medium Duty 8000 Series Door Closer
adjustment 8300/8500: Bi-pack packaging standard (regular arm and top jamb mounting) Exceeds 10 million cycles (witnessed and verified by UL) Non-handed Staked valves Standard, separate...
-
Pilot Rock CN-OKR Oak Knoll Collection Trash Receptacle
A top plate of 3/8-in. plate steel with a 10-in. diameter hole for depositing trash which eliminates the need for a separate, loose lid. ...
