[See subsections ...]
Search Results "Kitchen Work Surface"
Filters
Commonly Searched Documents
-
403 Walking Surfaces
-
403 Walking Surfaces
[See subsections ...]
-
Floor and Ground Surfaces: ADA Standard Section 503.4
Section 503.4 covers the current ADA Standards for the floor and ground surfaces at passenger loading zones.
-
22. Must an employer allow an employee with a disability to work a modified or part-time schedule as a reasonable accommodation, absent undue hardship?
If modifying an employee's schedule poses an undue hardship, an employer must consider reassignment to a vacant position that would enable the employee to work during the hours requested...
-
About this Study
About this Study Background In our previous work (Phase I Final Report: Interagency Agreement 00-CO-11111124-154, 2002 by Laufenberg et al 2001), basic processing techniques to produce...
-
11B-1005.3.2 Extended ground or deck surface
The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
305.2 Floor or Ground Surfaces
Floor or ground surfaces of a clear floor or ground space shall comply with 302. Changes in level are not permitted. EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
305.2 Floor or Ground Surfaces
Floor or ground surfaces of a clear floor or ground space shall comply with 302. Changes in level are not permitted. EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
505.6 Gripping Surface
The bottoms of handrail gripping surfaces shall not be obstructed for more than 20 percent of their length....
-
1133A.4, Item 1
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation....
-
1133A.4, Item 1
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation....
-
305.2 Floor or Ground Surfaces
Floor or ground surfaces of a clear floor or ground space shall comply with 302. Changes in level are not permitted....
-
609.5 Surface Hazards
609.5 Surface Hazards. Grab bars and any wall or other surfaces adjacent to grab bars shall be free of sharp or abrasive elements and shall have rounded edges....
-
505.6 Gripping Surface
Where handrails are provided along walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length...
-
Handrail Gripping Surfaces: ADA Standard Section 1008.2.5.3.1
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
a. Transfer Surface Adjustability
The MDE NPRM proposed that the same transfer surface height range of 17 inches minimum to 19 inches maximum be applied to both diagnostic equipment used in the supine, prone, or side-lying...
-
Door and Gate Surfaces [§404.2.10]
Door and Gate Surfaces [§404.2.10] The bottom surface of doors and gates on the push side must be smooth to a height of at least 10”....
-
Technical Bulletin: Ground and Floor Surfaces
UNITED STATES ACCESS BOARD A FEDERAL AGENCY COMMITTED TO ACCESSIBLE DESIGN Technical Bulletin: Ground and Floor Surfaces...
-
11B-404.2.4.4 Floor or ground surface
Floor or ground surface within required maneuvering clearances shall comply with Section 11B-302....
-
Delta How to Install a Pull-Out Faucet Featuring Touch20® Technology
With proper installation, your pull-out kitchen faucet with Touch20® Technology will bring years of stylish, efficient water delivery....
-
Rotational Penetrometer Measurements of Firmness and Stability
The results of the Rotational Penetrometer correlated with those of the Wheelchair Work Measurement Method....
-
American Standard Cadet 2-Handle High-Arc Bar Sink Faucet 2475F
This two-handle, centerset bar sink faucet belongs to our Cadet® Kitchen Suite and complements casual décor....
-
Firmness, Stability, and Slip Resistance [§302.1]
Firmness, Stability, and Slip Resistance [§302.1] Accessible floor and ground surfaces must be stable, firm, and slip resistant....
