When the surface is constructed of materials other than concrete, asphalt, or boards, cross slopes no steeper than 1:20 (5 percent) are allowed when necessary for drainage....
Search Results "Course Material"
Commonly Searched Documents
-
Cross Slope [1016.7.2]
-
711.2 Installation details
Insulation and coverings on or in the penetrating item shall not penetrate the assembly unless the specific material used has been tested as part of the assembly in accordance with this...
-
FAQ: Are Corada WorkGroups private?
Though a WorkGroup's content is integrated within Corada's existing database of other accessibility-related material, only WorkGroup members may see WorkGroup-specific content and activity...
-
[A] APPROVED
[HCD 1, HCD 2 & DSA-AC] “Approved” means meeting the approval of the enforcing agency, except as otherwise provided by law, when used in connection with any system, material, type of...
-
APPROVED
[HCD 1, HCD 2 & DSA-AC] “Approved” means meeting the approval of the enforcing agency, except as otherwise provided by law, when used in connection with any system, material, type of...
-
Findings
Findings The evaluation of the 35 playground sites in this study has provided some important information on the design, installation, and maintenance of playground surface material for...
-
Slip Resistance
Compliance with the standards requires specifying surface materials, textures, or finishes that prevent or minimize slipperiness under the conditions likely to be found on the surface....
-
§ 36.604(b)
(b) The Assistant Attorney General, after consultation with the Architectural and Transportation Barriers Compliance Board and consideration of the materials and information submitted pursuant...
-
§382.129(a)
carry out these instructions to the greatest extent feasible, consistent with FAA, PHMSA, TSA, or applicable foreign government requirements concerning security, safety, and hazardous materials...
-
Equivalent Facilitation
Equivalent facilitation is the concept of utilizing innovative solutions and new technology, design, or materials in order to satisfy the guidelines. ...
-
§ 36.604(b)
(b) The Assistant Attorney General--after consultation with the Architectural and Transportation Barriers Compliance Board and consideration of the materials and information submitted pursuant...
-
Accessible Classroom Style
This set-up is very helpful when participants need a surface to take notes and refer to materials....
-
§ 38.83(c)(1) Design load
a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches, with a safety factor of at least 3 based on the ultimate strength of the material...
- Reasonable Accommodation Training for Supervisors/Managers
-
What values are recommended for ground and floor surfaces along an accessible route?
In the Access Board research, the static coefficients of friction for a variety of common indoor and outdoor surfacing materials were measured in place using the NBS-Brungraber Tester with...
-
1008.2.6 Ground Surfaces
The type of surface material selected and play area use levels will determine the frequency of inspection and maintenance activities....
-
11B-1008.2.6 Ground surfaces
The type of surface material selected and play area use levels will determine the frequency of inspection and maintenance activities....
-
1132A.4, Item 4
Secondary exterior doors onto decks, patios or balcony surfaces constructed of impervious materials (e.g., concrete, brick, flagstone) may have a maximum change in height from the interior...
-
E202.3 Federal Contracts
ICT that is incidental to a contract includes materials which are, themselves, not deliverables under the contract....
-
7.2(2)(iii)
folding shelf attached to the main counter on which an individual with disabilities can write, and (2) use of the space on the side of the counter or at the concierge desk, for handing materials...
-
11B-1008.2.6 Ground surfaces
The type of surface material selected and play area use levels will determine the frequency of inspection and maintenance activities....
-
§ 38.125(c)(1) Design load
pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based on the ultimate strength of the material...
-
§ 38.95(c)(1) Design load
pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based on the ultimate strength of the material...
-
11B-705.1.1.3 Color and Contrast
The material used to provide visual contrast shall be an integral part of the surface....