Section 38.23(d) of the DOT ADA regulations requires all ADA-compliant buses and vans to have a two-part securement system, one to secure the wheelchair, and a seat belt and shoulder harness...
Search Results "State Requirement"
-
What kinds of securement equipment must be provided in buses and vans?
-
§8.31 Historic properties.
If historic properties become subject to alterations to which this part applies the requirements of §4.1.7 of the standards of §8.32 of this part shall apply, except in the case of the Urban...
-
504.3 Prompts (Section-by-Section Analysis)
504.3 Prompts (Section-by-Section Analysis) This proposed section would require authoring tools to proactively support the creation of accessible content by providing a mode of operation...
-
Sec.36.401(d)(3)
(3) The elevator exemption set forth in this paragraph (d) does not obviate or limit, in any way the obligation to comply with the other accessibility requirements established in paragraph...
-
1001.1 Scope
The provisions of Chapter 10 shall apply where required by Chapter 2 or where referenced by a requirement in this code. Advisory 1001.1 Scope....
-
C102.8.2 TIA 1083
Telephone Terminal Equipment Handset Magnetic Measurement Procedures and Performance Requirements, (March 2007), IBR proposed for Section 410.4.2....
-
1018.5 Obstacles
This section contains technical requirements for obstacles on beach access routes and resting intervals....
-
7.2.2.2 Extent of Impracticability
Where General Exception 2 permits exemption of an entire trail from the requirements of section 7.4.1 through 7.4.8, it may be beneficial to construct a portion of the trail to meet the...
-
Portable Units [4.1.2(6)]
Where ramps are provided, it is important that required door clearances are available at the required level landing....
-
4.1.2(5)(b)
(b) One in every eight accessible spaces, but not less than one, shall be served by an access aisle 96 in (2440 mm) wide minimum and shall be designated “van accessible” as required by 4.6.4...
-
F246.2 Distinct Viewing Locations
This section requires each distinct viewing location within a viewing area to comply with the technical requirements for viewing areas in 1015....
-
III-7.8300 Medical care facilities
The required percentage is 100 percent for special facilities treating conditions that affect mobility, and 50 percent for long-term facilities and nursing homes....
-
Stairways [ADA Standards §210, §504]
In addition, interior and exterior stairs that are part of a means of egress must comply with requirements in the ADA Standards (§504)....
-
Can accessible spaces be parallel instead of perpendicular?
The Standards do not specifically require that accessible spaces be perpendicular instead of parallel, but perpendicular parking spaces are preferred at facilities located on sites because...
-
11B-812.7.2 Marking
The blue color required for identification of access aisles for accessible parking shall not be used. Access aisle markings may extend beyond the minimum required length....
-
1018.5 Aisles in other than assembly spaces and Groups B and M
assembly purposes and Group B and M occupancies, the minimum clear aisle capacity shall be determined by Section 1005.1 for the occupant load served, but the width shall be not less than that required...
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area at the exterior side of the primary entry door and any required exit doors shall comply with Section 1126A. Notes: 1....
-
11B-403.7 Continuous gradient
ETA Editor's Note CBC requirement 11B-403.7 is not present in 2010 ADAS. Therefore, CBC requirements related to continuous gradients are more stringent....
-
11B-1001.1 Scope
The provisions of Division 10 shall apply where required by Division 2 or where referenced by a requirement in this chapter. [2010 ADAS] Advisory 1001.1 Scope....
-
11B-206.4.7 Restricted entrances
ETA Editor's Note The ADA requirements included at Subsection 11B-206.4.7 are provided for information only. The CBC scoping requirements are more inclusive. ...
-
§ 38.113(b) Passageway
Doorways required to be accessible by paragraph (a) of this section shall permit access by persons using mobility aids and shall have an unobstructed passageway at least 32 inches wide leading...
-
11B-808.3 Clear floor space
Exception: In alterations, wheelchair spaces are not required to be located within the defined area of raised jury boxes or witness stands and shall be permitted to be located outside these...
-
1018.5 Aisles in other than assembly spaces and Groups B and M
assembly purposes and Group B and M occupancies, the minimum clear aisle capacity shall be determined by Section 1005.1 for the occupant load served, but the width shall be not less than that required...
-
11B-505.3 Continuity
Exception: In assembly areas, ramp handrails adjacent to seating or within the aisle width shall not be required to be continuous in aisles serving seating....