Vehicle spaces serving van accessible, standard accessible, ambulatory and drive-up EVCS shall be 216 inches (5486 mm) long minimum and shall comply with Sections 11B-812.6.1 through 11B...
Search Results "Section 505"
Filters
Commonly Searched Documents
-
11B-812.6 Vehicle spaces
-
§ 38.83(a)(1) General
., lift, ramp or bridge plate) complying with either paragraph (b) or (c) of this section and sufficient clearances to permit at least two wheelchair or mobility aid users to reach areas...
-
§ 38.71(d)
Vehicles previously designed and manufactured in accordance with the accessibility requirements of part 609 of this title or the Secretary of Transportation regulations implementing section...
-
1009.12 Alarms/emergency warning systems/accessibility
ETA Editor's Note Sections from California Building Code Chapter 10 that are not adopted by the Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
11B-206.4.3 Entrances from tunnels or elevated walkways
provided for pedestrians from a pedestrian tunnel or elevated walkway to a building or facility, all entrances to the building or facility from each tunnel or walkway shall comply with Section...
-
11B-221.2.1.5 Stadium-style movie theaters
The required wheelchair spaces shall be located on risers or cross-aisles in the stadium section that satisfy at least one of the following criteria: 1. ...
-
11B-223.2.1 Facilities not specializing in treating conditions that affect mobility
psychiatric and detoxification facilities, at least 10 percent, but no fewer than one, of the patient bedrooms or resident sleeping rooms shall provide mobility features complying with Section...
-
§ 37.42(d)(3)
(3) Before proceeding with constructing or modifying a station platform covered by paragraphs (c) and (d) of this section, the railroad must obtain approval from the FTA (for commuter rail...
-
§ 38.91(d)
Vehicles previously designed and manufactured in accordance with the program accessibility requirements of section 504 of the Rehabilitation Act of 1973, or implementing regulations of the...
-
1009.12 Alarms/emergency warning systems/accessibility
ETA Editor's Note Sections from California Building Code Chapter 10 that are not adopted by the Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
11B-406.5.12 Detectable warnings
Curb ramps and blended transitions shall have detectable warnings complying with Section 11B-705. U.S....
-
11B-812.6 Vehicle spaces
Vehicle spaces serving van accessible, standard accessible, ambulatory and drive-up EVCS shall be 216 inches (5486 mm) long minimum and shall comply with Sections 11B-812.6.1 through 11B...
-
Ampetronic MLD9 MultiLoop Driver Hearing System
For detailed information on approvals, standards compliance and how to interpret the technical parameters on Ampetronic datasheets, please visit the support section of our website or contact...
-
2.6 Communications.
information about accessible facilities; and 5. 28 CFR § 35.163(b) also requires the use of the international symbol for accessibility at each accessible entrance of the facility. 2.6.2 Section...
-
11B-410.1 General
Accessibility scoping requirements for elevators and lifts are located in Sections 11B-206.6 and 11B-206.7; technical requirements are located in Sections 11B-407, 11B-408, 11B-409 and 11B...
-
Door Maneuvering Clearance
Section 404.2.4 addresses maneuvering clearances at manual doors, doorways, and gates....
-
11B-235.2 Boat slips
Boat slips complying with Section 11B-1003.3.1 shall be provided in accordance with Table 11B-235.2....
-
Sides of Curb Ramps
Section 406.3 addresses the sides of curb ramps and specifies that side flares, where provided, have a slope of 1:10 maximum....
-
Alterations to Residential Facilities
Section 4.1.6 of the UFAS requires federal, state, and local government housing to comply with the general requirements for alterations to facilities....
-
1129B.3, Item 2
SECTION 1129B - ACCESSIBLE PARKING REQUIRED 1129B.3 Parking space size. ...
-
1131B.2, Item 1
SECTION 1131B - PASSENGER DROP-OFF AND LOADING ZONES 1131B.2 Passenger loading zones. 1. General. ...
-
4.Information, documentation, and training
Manufacturers should include in general product information the contact method for obtaining the information required by this section....
-
Typical Day One - Basic Facilities Requirements
(30 minutes) This section will give you an overview of the Law including effective dates, regulations, design standards, enforcement and exemptions....
-
3.3.3 Presentations about MDE Types
This material is described further in Section 4.3 (imaging equipment) and Section 4.1 (tables and chairs)....
