Door Protection Plate 225S 0.060" gauge Kydex Materials: - Kydex® Colors: - CBO - Calcutta Black; KGO - Beige; KHO - Chocolate
Search Results "Gripping Surface"
Commonly Searched Documents
- Hager Companies Door Protection Plate 225S
-
(1) Transfer Surface Location for Diagnostic Equipment Used in the Supine, Prone, or Side-lying Position
its depth spanned the examination surface’s width, and was located near the center point of the diagnostic equipment surface....
- Sargent 8700 Surface Vertical Rod Exit Device
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE. ...
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE....
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE....
-
7. Commit to Ongoing Maintenance of Accessible Playground Surfaces as a Responsibility of Ownership
surfaces....
- Inpro Corporation JointMaster® AR Series Seal Expansion Joint Systems
-
Study Questions
Study Questions The purpose of this study was to evaluate a variety of playground surfaces, their ability to meet accessibility requirement, their costs upon initial installation and...
- UltraPlay Engineered Wood Fiber Surface
-
Data Collection Procedures
study surfaces. ...
-
Cross Section of Gripping Surfaces
The Access Board is considering whether the above cross section dimensions would be appropriate for the gripping surfaces of transfer supports on diagnostic equipment used by patients in...
-
6. Transfer Surface Height
Transfer Surface Height 6.3 Diagnostic Imaging Equipment Refer to the Rationale found in Section 5.3 for M301.2.1 and to Section 4.3....
-
405.9.1 Extended Floor or Ground Surface
405.9.1 Extended Floor or Ground Surface....
-
505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
5.2.2.2 Transfer Surface Depth Recommendation for M302
5.2.2.2 Transfer Surface Depth Recommendation for M302 The Committee recommends a minimum depth requirement of 17 inches for equipment used by patients in seated positions....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
T302.2 Slip Resistant
Walking surfaces shall be slip resistant....
- Tile Tech Pavers® Traver-Pave™
-
11B-403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
11B-403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
Carpet [4.5.3]
Carpeting can significantly increase the amount of force needed to propel a wheelchair over a surface....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
403.1 General
Walking surfaces that are a part of an accessible route shall comply with 403....