(3) The maximum weight and dimensions (length, width, height) of the device to be used by an individual that can be accommodated in the aircraft cabin consistent with the safety regulations...
Search Results "Full Length Mirror"
-
§382.133(f)(3)
-
C1-3. Accessible Route Width
If No, the accessible route may narrow to 32 inches wide for up to 2 feet in length. Yes _____ No _____...
- Bobrick ClassicSeries Surface-Mounted Soap Dispenser B-42
- Pilot Rock WPTS Square Frame Picnic Table Using Formed Steel Channel
- Pilot Rock WPTS Square Frame Table Using Aluminum
-
1017.8 Resting Intervals
This section contains the technical requirements for the length (1017.8.1), width (1017.8.2), and slope (1017.8.3) of resting intervals; and for a turning space (1017.8.4) where resting...
-
4.1.1(5)(a)
Full compliance will be considered structurally impracticable only in those rare circumstances when the unique characteristics of terrain prevent the incorporation of accessibility features...
-
406.8 Detectable Warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
- Cavity Sliders USA Inc. FH Ceiling Mount Track
-
11B-1003.2.2 Boarding piers at boat launch ramps
Where the total length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9144 mm) minimum, gangways shall not be required to comply with Section...
-
11B-1003.2.2 Boarding piers at boat launch ramps
Where the total length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9144 mm) minimum, gangways shall not be required to comply with Section...
-
Conclusions
A depth of 15in. for a seating surface was found to be suitable based on median values of buttock-popliteal length and wheelchair seat depths....
-
1017.4 Passing Spaces
Where the full length of a trail does not fully comply with the technical requirements in 1017, a passing space is required to be located at the end of the trail segment that fully complies...
-
M305.3.1.1 Horizontal Position
The length of gripping surfaces on horizontal standing supports shall be 4 inches (100 mm) minimum except for diagnostic equipment containing a wheelchair space which shall comply with M305.3.1.2...
-
Sec.36.309(c)(2)
(2) Required modifications may include changes in the length of time permitted for the completion of the course, substitution of specific requirements, or adaptation of the manner in which...
-
§ 36.309(c)(2)
(2) Required modifications may include changes in the length of time permitted for the completion of the course, substitution of specific requirements, or adaptation of the manner in which...
- Bobrick ClassicSeries Surface-Mounted Soap Dispenser B-40
-
Handrail Extensions [§505.10]
The length is measured to the start of the return radius....
- Gamco Recessed Towel Dispenser - TD-3
-
T602.3 Approach
One full unobstructed side of each wheelchair space shall adjoin or overlap a passenger access route....
-
Accessible Presentation / Speaker’s Platform - Traditional
Click [here] ... for a full-page, printable handout....
-
1016.8 Resting Intervals
This section contains the technical requirements for the length (1016.8.1), width (1016.8.2), and slope (1016.8.3) of resting intervals; and for a turning space (1016.8.4) where resting...
-
Stairs
Full handrail extensions at stairs are not required where they would project hazardously into circulation paths (§505.10, Ex. 3)....
-
Sections 4.8.5 and 4.9.4
Section 505.6 requires handrail gripping surfaces to be continuous along their length and not to be obstructed along their tops or sides....