Search Results "Electroacoustic Performance Standards"
-
ASA Standards Store
-
E.2. - Where an agency uses a best value "trade-off" source selection process, may it trade off applicable technical provisions of the Access Board’s standards where an offer provides strong technical merit, strong past performance, or a lower price?
For example, if a product is available that meets the technical provisions of the Access Board’s standards, the agency would not be required to make the purchase if significant difficulty...
-
11B-608.2.2 Standard roll-in type shower compartments
Standard roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
Guidance on the 2010 ADA Standards for Accessible Design
Guidance on the 2010 ADA Standards for Accessible Design Reproduction of this document is encouraged....
-
608.2.2 Standard Roll-In Type Shower Compartments
Standard roll-in type shower compartments shall be 30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
Reason the Access Board is issuing the proposed standards
Section 510 of the Rehabilitation Act (29 USC 794f) requires the Access Board, in consultation with the Commissioner of the Food and Drug Administration, to issue standards that contain...
-
ABA Accessibility Standard for GSA Facilities Pocket Guide
Pocket Guide to the ABA Accessibility Standard for GSA Facilities With Selected Sections from GSA’s Federal Management Regulation Final Rule Adopting GSA’s ABA Accessibility Standard...
- American Standard Cadet 2-Handle High-Arc Bar Sink Faucet 2475F
-
SUBCHAPTER E. REGISTRATION TO PERFORM REVIEWS OR INSPECTIONS
[See subsections ...]
-
B. State Agencies Performing Oversight Responsibilities
The State agency responsible for the administration of vocational education programs must adopt a compliance program to prevent, identify and remedy discrimination on the basis of...
-
§1630.10(b) Qualification standards and tests related to uncorrected vision
(b) Qualification standards and tests related to uncorrected vision....
-
3.3 Comparison of Dimensions with Standards and other Anthropometric Studies
3.3 Comparison of Dimensions with Standards and other Anthropometric Studies...
-
1) Where the Standard specifically refers to 303
1) Where the Standard specifically refers to 303, such as 403.4 changes in level for walking surfaces: Here it is clear that changes in level that comply with either the ¼" maximum vertical...
-
F105 Referenced Standards
[See subsections ...]
-
2010 ADA Standards
104.1.1 Construction and Manufacturing Tolerances. All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific...
-
1991 ADA Standards
3.2 Dimensional Tolerances. All dimensions are subject to conventional building industry tolerances for field conditions.
-
406 Standard Connections
[See subsections ...]
-
Implication for Standards and Design
Close to 200 community dwelling adults who independently transfer have been evaluated during phases 1 and 2 combined of this multi-year study. The main difference between phase 1...
-
406 Standard Connections
[See subsections ...]
-
II. LEGAL STANDARD
Summary judgment is only appropriate where the “materials in the record, including depositions, documents, electronically stored information, affidavits or declarations, stipulations...
-
Guide to the ADA Standards
[See subsections ...]
-
2.5 National and International Standards Settings Organizations and MDE Activities
2.5 National and International Standards Settings Organizations and MDE Activities As mentioned in Section 2.4.2, MDE must already meet a variety of standards before it can be marketed...
- American Standard Arch Single Handle Pull-Out Kitchen Faucet with Soap Dispenser 4101.101
-
Tactile and Visual Signs [ADA Standards §216.2, §216.4.1]
Tactile and Visual Signs [ADA Standards §216.2, §216.4.1] The IBC requires exits and exit access doors to be marked by illuminated exit signs (§1011, §1003.2.10)....